20 Most Recent Speed Queen AWN432 Washer - Page 4 Questions & Answers

open front panel with 5/16 look water or oil leaking . if oil Tranmisson than call tech

This may not fix it but it's always the first thing I try. Unplug the unit, wait 10 minutes, then plug it back in. Turn it on and see if you get the error. If you don't, you just had a small power surge that confused the electronics. If you still do, you'll need someone who knows more about this specific machine.

Lubricate the idler bearing.

check here............. http://www.partselect.com/JustForFun/Speed-Queen-Fault-Codes.aspx cheers

Ed23 code is the lower drive board https://www.google. com/#q=commercial+speed+queen+front+load+washer+error+code+reads+Ed+23

You could try calling Speed Queen Support at 800 552 5475. They may be able to walk you through it or send you a document. I have used them as my SQ wasn't spinning up to high speed, so the cloths came out wetter and wouldn't dry in the dryer. I called them and they told me how to diagnose the problem. The cause was that the belt is loose and I'll need a new belt. Another guy told me it was the motor which was a much more expensive fix, and not something I believed..good thing. So give them a call.

Call Speed Queen Support 800.552.5475. They don't sell parts but can tell you where to get them.

Speed Queen Support is your best bet 800.552.5475. There's no charge and they know their machines. They also don't sell parts so they won't try to sell you anything.

Call Speed Queen Support...they are very helpful. I spoke with a guy by the name of "Tim" who was very helpful.

2018 Speed Queens did not have lid locks. The 2019 machines do. The lid lock can not be disabled. If the lid is stuck closed, you can, with 30 pounds of pressure, raise the lid without damaging the lock. (unlike any other machine on the market)

Change out the water valve. The water valve is what the water hoses are hooked up to on the rear of the machine. This is a pretty easy replacement. The new one goes on like the old one comes off. Turn the water off and disconnect the water hoses from the back of the machine. Sometimes there is one hex head that is removed and the valve tips out for replacement. Depends on the year and model.

Is this a washing machine or dryer

https://www.youtube.com/watch?v=5ecbL94DjeI

remove the top cover tilt down the control panel turn the knob on the water selector when doing that look at the backside of switch panel watch the cam riding on the switch it has an adjustment try adjusting and if that does not work then you have a bad switch

it probably yes