20 Most Recent
Toshiba TEC B-SX4 Thermal Label Printer - Page 3 Questions & Answers
My printer always showing error
Power on with Feed and paused epressed and wait for message (1) diag ...
with feed advance to 5 sensor adjust.
place the backing under the sensor.
Depress pause so as to have transmissve V4.xx if not the case presse restart 5 seconds the value should change.
press pause to vlid the value.
Switch off and 5 seconds later on (Wait for the led to go off)
The transmissive sensor is set.
Lable feed not working
- check that i the driver taht you have selected detection transmissive.
- Check in the diag menu >sensor adjustement that there is 2 v difference bewteen the backing and when you are on a label if not the case place the backing under the sensor and press feed 5 seconds (you should have transmiise 4,2 V approx. Check that when you put a label the voltage drops to 0 or is down by 2 volts.
Print head changing
Two screws to remove and disconnect the cables. But take care you have to check the angle which is on the print head. You may have to adjust the position of the print head. The edge must be aligned on the top od the platen. Other wise the printing is fusy.
Download mode
use the tool to resend the firmware or chek taht you don't have the three buttons pressed at power on. To check that remove the keyboard cable.
Paper gap sensor
Ok, this is easily solved in 3 different ways
1) Driver: Download the greatest driver I know, the one developed by the NiceLabel guys:
www.nicedrivers.com
you need to go on right click in te driver(Start/Control panel/TEC Toshiba...) choose properties. In options you will have the chance to verify the gap mode(continous/black mark/ etc). You can also calbrate your printer from there.
2) If your printer needed to calibrate, turn-it off, then, by holding the feed button, turn-it on and let go after 3 seconds, or after you see a light. It will calibrate automatically with your label size at that moment, it may also print the printer settings, so be prepared for stoping the baby.
3) If you have a barcode software(did i say I reccomend NiceLabel?), you can set the instructions on 1) directly from printer settings.
Good luck, peace.
Bartender was supplied with Printer but laptop
Hello, The software that comes with the printer is pretty basic anyway. If you need to print with variables, then you have to buy from dealer.
The demo version free for 30 days that you had is available at seagullscientific.com or similar
Barcode printer type: TOSHIBA SX4
sensor
Diagnostic boot
Feed PAuse button pressed and switch on Keep button prressed until message (1)Diag ...
with feed goto 5 sensor adjustements.
Pause to enter the menu
select the sensor you want to calibrate!.
Feed or restart button for 5 seconds until a star appears.
Switch off and on the calibration is stored in Eprom
Not finding what you are looking for?