20 Most Recent
Toshiba TEC B-SX4 Thermal Label Printer - Page 2 Questions & Answers
Labels not moving forward enough
Check that you have activated tyhe right detection and not using continuous material in the driver. You should use Transmissive or blackmark depending on your labels.
Rbn forward
In the driver options decrease the ribbon rewind motor value.
What should the zebra printer be set at for a 4x6 label
Label size should be as follows;
Width 4.00 cm
Height 6.00 cm
Margins;
L 0.20cm R 0.20cm T 0.15cm B 0.15cm
Basically Label setup should be the physical size of the backing paper, the L/R margin size is the gap between the edge of the backing paper and the edge of the label and the T/B margin size if half the gap between two adjacent labels....... Hope this helps.
How can I reset the printer to factory settings?
To get the printer to factory setting you have to do a parameter clear.Switch on with buttons FEED ans PAUSE pressed.When (1) Diag VXXX is dosplayed release the buttons.press on FEED several times to have (6) Ram clear the press pause.With Restart button select parameter clearPress PAUSE twice and wait for Complete on the displaySwitch off and on
Hello, we are living problem
Either you driver is not correctly interpreting the image data or you have a problem with you connections. This is syntax error detected due to missing or unorrect datas.
Error message is printer jam
go to sensor adjustment and fiollow the instructions.
When the right sensor is selected press feed or restart for 5 seconds (i.e until a little star is displayed next to the value)
We are using Clear Labels (Width - 2.5 &
The printer cannot do the difference.
Have your supplier to print on the reverse side a dark color spot coresponding to the size of your label and use the transmissive cell detection
Not finding what you are looking for?