Top 20 D-Link DAP-1522 Xtreme N Duo Wireless Bridge/Access Point (DAP-1522/B) Pre-802.11n - Page 6 Questions & Answers

See this link, it may help you.

Use an Ethernet cable to connect from the port on the DSL modem to the WAN/Internet port on the D-Link modem.

New firmware is created/released only when there is a problem with the current firmware. No problems, thus no new firmware.

Modems do not use IMEI -- it's only mobile-phones that do.

It shows that you have physical connection to the DSLAM at your service provider but may not authenticating with the server. set up the ADSL basic setting with the model name http://support.dlink.com/index.aspx or If you still cannot browse the Internet or not able to access the page. Follow D-link Router Support for share more details.

You might want to put the IP address of the sites you want blocked.

Here is the manual: http://files.dlink.com.au/Products/DWR-113/Manuals/DWR-113_A1_Manual_v1.01(WW).pdf

Connect to your router via an ethernet cable. Go into the settings and pick another password, noting it down carefully (it is case-sensitive). Save settings, then go into your PC network settings and enter new password. Disconnect cable and try wifi.

The internet speed all depend on the network depending on the company and the signal strength

Some networks are configured to *NOT* respond to PING requests.

You did not say where are your two computers. Anyway, computers should work on most subnets routes except between 10.20.30.0 and 10.20.40.0 subnet. Static routing should be set on two computers not on routers. Assume computer A is connected to 10.20.30.252 Router A and Computer B is connected to router B. On Computer A, you need to add route to -inet 10.20.40.0/24 via GW 203.187.106.147, and on computer B to set rotue to -inet 10.20.30/24via GW 203.187.106.138. That is all you need.

Skybox F5 mini review

The final solution is a factory reset of your router. You can do a factory reset by logging into the router using you browser. Go to the settings and perform a factory reset If you forgot the router password, you ill have to do a factory reset by locating a small hold on the back of the router and insert the tip of of paper clip for about 10 seconds while the power is on. The router will be reset to out of box status and then you can set-up form scratch.

Reset it to the "factory" settings, and set a new password.

You need to access router menu . Try 192.168.0.1 in your web browser address bar. You can really screw things up if you don't know what you are doing. Get the manual and read it 1st.

Follow this simple tutorial video to resolve your usb flash drive access problem.

Yellow light can mean connecting at 100 mbps instaed of 1000 ( 1 gigabit)

Use the "Add New Hardware" wizard to get Windows to detect the modem.

Ask the owner of the router for the SSID (name of the network) and the password.

Reset the router to "factory" settings. Then, set a new SSID and a new password.