Sometimes these memory cards have a small (switch) tab on the side of them which needs to be in the correct position.
Check it out and slide the tab fully to the other position
It depends, if you are using regular Alkaline batteries, those are known to go dead really fast. Better if you try some rechargeable batteries with a rating of at least 2100mAh, anything smaller than that will drain just as quick as Alkalines.
The most common cause for telling you that the card is locked is having the tiny slide switch on the side of the card in the wrong position.
- see photo below:
Set the lock slider to locked or unlocked.
The down position will enable write-protection, locking the card.
The up position will unlock the card, enabling you to save and erase data on the card
The best way to transfer videos (and pictures) from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.
Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy files from the card to the computer's hard drive, the same way you copy any other files.
The best way to transfer pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.
Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo management program such as Picasa.
Organize edit and share your photos
First the manual in pdf format can be found here:
http://resources.kodak.com/support/pdf/en/manuals/urg01042/C182_UG_GLB_en.pdf
and saved to the computer for future reference.
An extended user guide can be found here:
http://resources.kodak.com/support/pdf/en/manuals/urg01041/C182_xUG_GLB_en.pdf
I am not quite sure what you mean by "printers for the camera". Printer drivers would normally be on the computer and you would print from there. The manual however mentions "pictbridge" direct printing and I don't think you need a separate driver for this, just connect the camera and printer with the appropriate USB lead and control the functions from the printer's control panel.
Another way of printing is from the EasyShare programme supplied on the original disk that came with the camera. This programme is no longer available for download from Kodak.
Cheers
The internal memory is very small and will only take a few pictures. Just enough to test the camera. Your camera also accepts SD and SDHC cards, which are not expensive. You can put lots of pictures on the SD or SDHC cards.
You also could connect the camera to a PC or MAC and send the pictures over after you installed Kodak Picture easy share.
After you backed up the pictures that way, you can delete the pictures in the camera. Always make sure you have at least 2 backups from your pictures.
Look at the memory card. SD cards have a slide switch along one edge. The position farthest from the metal contacts locks the card, protecting it from writes. The position nearest the contacts unlocks the card.
sounds like that card has become faulty. Many things can make go faulty. If you formatted it in a computer that will make it faulty. Sometimes you can still format it in the camera
You don't need any special software. The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or, despite what I said first, you can use any photo cataloging program such as Picasa ( http://picasa.google.com ).
TRANSFERRING PHOTOS TO COMPUTERIf your photos are stored on the memory card, then removethe memory card from the camera and insert it into an USB memory card reader.Connect this USB memory card reader and memory card into the USB port of yourworking computer. Your computer will see this as an USB Mass Storage Device oran external storage device; you can then open the folder on the memory card andcopy the photos to your computer.Memory card reader is a handy device and is inexpensive. Youcan copy photos from other cameras and you can also download photos off yourmemory card to someone else's computer without the need of installing anyprograms.
Hello, Sorry to say you will need to send it out for repairs, There are shops available on the web that can make arrangements to mail it to them for repairs.