20 Most Recent Ricoh Aficio SP C231N All-In-One Laser Printer - Page 4 Questions & Answers

try saving document to desktop then print it. Sometimes there is info in pdf you don't see. I have had customers that have this type problem and after they save it prints just fine.

1. Improper firmware update. 2. SD Card size greater than 2 GB used. 3. Multiple ROM data folders in SD Card. 4. Improper Java firmware update. 5. Power failure during firmware update. 6. Power line issues on the outlet. Replacement of the Controller Board is necessary in case SC Code 878 occurs.

SC302 is a charge roller current leak. Replace PCU.

Hi, my experience with this machine is that the gear that drives the black pcu breaks or cracks. Usually caused by the pcu being too hard to turn. I always turn the developer gear in the pcu before installing it just to loosen the toner.

In the back of the machine on the nozzle assembly there is a toner end sensor. It is possible it just needs blowing off clean. Excess toner spillage in that spot prevents the sensor reading correctly. However, if that do not work, it may need new sensor.

This is one possibility, but there are other solutions if this don't work. The black toner is not set message is displayed. The black toner is not set message is displayed even though the black toner is set. [Cause] There is a problem with the BCU lift. The communication with the ID chip is faulty. [Action] Update the BCU software version to the latest version.

Please the error code and more details.

press the user tools /counter button scroll down till you see language should be last one press ok then select English press ok

need more info.

laser code could be laser unit or board problem that lser unit plugs into.

Try checking on the two ends of the rod that supports the transfer belt,you will see the gears that rotate the belt and this gears are held into position by hooked washers it is most likely they are broken and are not hooking to the high tension spring that holds them in position,replace them and reset in the usual manner by going to the maintainance menu on the control panel of the copier.