20 Most Recent
Ricoh Aficio SP C231N All-In-One Laser Printer - Page 3 Questions & Answers
What is error code 460 on a Ricoh Aficio SP C811Dn
SC 460 The problem may just be dirty separation components that a cleaning may resolve. The code refers to the following:
High voltage power: Separation bias output error
The status of the power pack is checked every 20 ms. This SC is issued
if the EGB detects a short in the power pack 10 times at D(ac).
1. Replace the high-voltage supply cable.
2. Replace the high-voltage power supply unit
3. Replace the IOB.
Ricoh Aficio 2232c leaving stripes on backside
AS I understand you have black stripes on the back side of the print, so if this is the case, the Image transfer cleaning blade need to be replaced. Part number is: Genuine Ricoh Aficio 2238C Transfer Belt Cleaning Blade Ricoh AD04-1081, AD041081
Ricoh aficio SP 3510 error code SC 542
This is a fuser fault code. First need to check and repair fuser. Buy a new or rebuilt fuser or replace items that cause problem could be thermistor needs to be replace to over temp sensor is bad and needs to be replace or lamp. Once replace then you can clear code. You can buy. Service Manual will explain how to get into service mode and reset fault code. Or post how to reset code on web
Solve error code sc360 aficio mp4000
When you replace developer, make sure to clean the waste toner path on the PCU. Waste toner in combination with new developer causes trouble. After replacement of the developer use a piece of paper to block waste toner from falling into the DV-Unit. Then run SP2-801 and do process control.
Then make 100 copies and after that remove the piece of paper. A Ricoh tech told me that the amount of toner in the developer can be very high, so he always made 100 copies before removing the piece of paper. I'm doing this for a long time and I never had trouble with SC's related to TD-sensor.
How i reset maintenance on ricoh aficio sp 4310n
The machine will automatically reset the maintenance message when the fuser is replaced.
There is a looped wire on the fusing unit connector containing a thermo fuse (a thin wire that quicly melts, and then short the cirquit).
If you don't want to replace the fuser yet, you can probably set the machine to meter charge, SP mode 5930, and then reset the maintenance counter with SP mode 7804.
You can of course take out the fuser, and replace it with a dirt cheap thermo fuse bought from Ebay. Then set the fuser back into the printer, and it will clear the maintenance message automatically.
Either way should work fine, at least it used to do that on the previous model - and it is almost identical.
Not finding what you are looking for?