Top 20 Kenmore 22422 Top Load Washer Questions & Answers

The washer could be stuck the seating .

Drain Pump is the most likely thing. Although could be leaking hose, or cracked tub, or leaking tub seal

Could be a tub seal leaking (not likely), or water pump leaking (very common), cracked outer tub, leaking hose. You would really need to take washer cabinet off machine to be able to see where it's actually leaking.

Fill setting has to be adjusted and the belt is slipping on the spin cycle and not generating enough centrifugal force to get the water out.

needs new brushes on the motor..... cheers

sounds like the contacts in the timer are burned or siezed

does the motor hum? It is either a bad motor, clogged pump, or a bad timer If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a

ABDULLAH,CHECK POWER OUTLET MAKE SURE HAVE POWER, MAKE SURE SWITCH ON TOP DOOR IS NOT STUCK,, TOMORROW, CALL SEARS REPAIR CUSTOMER SERVICE FOR MORE HELP!!

Lid switch is faulty. Listen for a click when you shut the lid. If there is not click you have a bad lid switch

It is more than likely the lid switch. Most modern machines will fill with water and then wait for the lid switch. If it is bad they will just sit there.

sounds like no water coming into washer?if you go to fill it do you hear a buzzing or humming sound?if so bad water valve located in the back where the hoses connect to the washer or the water shut off is off in the house and no water going to the washer.the model number you sent is to long,after the 110 it should have 8 more numbers and that's it.

www.kenmore.com/customer-care

Sound like it could be a lid safety switch.

Loose belt, belt broke, belt came off, transmission bad, wires are broken.

This could be a bad lid switch. it can cause the drian and spin from occurring. A blocked pump could also cause no drain.

Do you happen to hear a humming noise coming from the machine after the tub fills? This might indicate that the motor is spinning, but the belt that connects the motor to the rest of the machine works is broken. It is located underneath the washer. Tip the washer a bit and have a look. If it's broken, you'll probably find the belt laying on the floor. Take that to an appliance parts store where they can match it up with a new one. Installation is not too difficult. The belt will go around the motor pulley, the transmission pulley, the water pump, and in some cases, a spring-loaded tensioner. I hope this helps! :) -Jason

Make sure the water supply is properly connected and open. Could also be a loose connection. If it is new, call the store. Hopefully it is still under warranty. Do not attempt to service it yourself, because that would void the warranty.

There is a motor on the bottom. You can see it if you lay the machine down. The motor has a belt that attaches to a transmission. The belt could be loose or off. The transmission could be bad, or the spindle into the drum is stripped.

TRY SWITCHING THE HOSES.

You may have a tub seal leaking from transmission. Check out YouTube under washer leaking oil. You may see what the problem.