Clutch needs to be replaced that is why it is not spinning out. There is a clear rubber hose that goes from the fill valve on the top left of the machine down towards the bottom of the tub on the right side under the cabinet. Check and see if that hose has a hole in it of possibly came loose on either end. If you need further help, reach me via phone at https://www.6ya.com/expert/steven_a67ead41eb5fc62a
Under the lid there should be a small hole with a push down flap and that should be the automatic stop, which can either be a bad switch under the top of the machine or could be a broken trip/ prong on the lid that pushes this button when the lid is dropped. When the machine reaches it's spin cycle time leave it turned on and raise the lid push down on this flap with something careful to keep hands out of the washers tub and see if it works then!
If the lid switch is faulty, or incorrectly adjusted, the drive motor is prevented from running. You do not say whether your repair man replaced the switch or the mechanism, but draining and spinning will only happen when the lid switch is engaged.
Could be a loose basket nut, or on the bottom tub support there are a few springs that help locate the tub. One of the springs could have come off or broke.
Yours is a 2 speed motor. Does it spin in 2 different speeds. If so, then it most likely is designed with only to agitate in 1 speed. If it only spins in one speed, then your motor is defective
I expect you will need to dismantle first and examine each part as it is removed and make a list.
Your description indicates at least a main bearing problem but with what seems to be such a complete failure there is certain to be "failure-related damage" to consider.
I bet your problem is in the timer control. There is a piece of cardboard that can be easily removed. You can then see metal extension rods with contacts attached. These rods can be adjusted so the contacts can make better contact. Here is a link to help you better understand. https://youtu.be/pdiDGySo3uI
if they won't go back into the slots pull the frame out and reinstall it it's not lined up with the back wall correctly,you have to drop the frame in place get the back wall and line up the outside edges the plastic strips and make sure they go into the frame and then push down on the frame where the clips go in,if the frame isn't down you'll never get the clips in
Hello Dbriner,
It would appear that the lid switch is defective and is in need of replacement. I included a video showing basically how to replace it (It is a series 80 machine but that is minor).The steps are the same.
Your part can be found here for $29.65 +Shipping
Good Luck!
Rich Lilja
Kenmore Washing Machine Lid Switch Assembly WP8318084
Jun 26, 2011 - Uploaded by XR600RQJ
Washing machine Indesit starts to flash for longer and longer ...How do you unlock the door when the power is off?? every time i turn it ... My washing maschine ( Indesit WITXL 129 ) had the same problem - 6 from 9 LED lights ..