Another possible reason why your Kenmore Elite Oasis dryer model 110.67042600 won't start is because the door switch is defective. The door switch is located on the door of the dryer. To check the door switch:
1. Unplug the dryer from the wall outlet.
2. Open the door of the dryer.
3. Locate the door switch on the door of the dryer.
4. Use a multimeter to test the door switch for continuity.
If the door switch is defective, it will need to be replaced.
Hi,
This sounds like a power failure error. It happens when power flow is not occurring properly to your machine. You'll need to press the cancel button 2 or 3 times before the error is wiped away. If it comes back, please have your machine serviced. You can call kenmore to help with this by dialing 1-844-553-6667.
Thank you.
That is more indicative of a fan failure. The element is supposed to get hot, but the fan blows the heat through the clothes and cools the element at the same time.
What exactly is this 'loud noise'? Is it a constant grinding or rumble sound that changes with drum speed or is is an occasional thumping, banging noise as the drum speeds up or slows down? A grinding or rumble is often a drum bearing and Thumping is commonly the 'suspension' the drum rides in to stop it 'walking across the room or shaking itself to pieces as it goes into high spin speeds. Your machine's age will only affect you if it is a very old machine and parts are difficult to find.
Start with the heating element. You won’t need a wiring diagram for that and it’s the most likely problem with the dryer. Watch a YouTube video on how to install.
Thanks for question.
This error occurs when the problem is with the overflow contact. You will notice that the door will not unlock and the drain pump will be draining excess water.
Solution:
Unplug the washer and turn of both cold and hot water faucets.
Ensure that the drain hose is clear and not damaged.
Ensure that the pump filter is clean.
Replug the washer.
Call a technician for diagnosis or replacement of the overflow contact or the pressure switch
Hi,
Just coming from a basic perspective, please test the powe outlets that your dryer uses with other devices so that you ensure that the power source isn't at fault. Thank you.
Hi,
Please contact a professional welder to help with this task or reach out to Kenmore to recommend the best technician in your area to reach your goal. Kenmore's phone number is 1-800-366-7278. Thank you.
Child Lock
The CL indicates the unit is in a Control Lock mode. This is sometimes referred to as child lock and is meant to prevent accidental option or cycle changes while the dryer is running. ... This is the keypad that turns the control lock feature on or off by pressing and holding the switch.Nov. 28, 2014
It is a gas appliance and as such should only be worked on by a qualified, registered gas technician. Call in a professional please. The gas to air mix is wrong. Techs use 'sniffers' to correct these days. You also have some sort of ignition or sensing problem. Your fixing method of 'let's try replacing this', never works and is expensive.
Sounds like the motor is going into thermal overload and shutting down. If you here a Buzzing noise when you start dryer motors bad. If after you start the dryer wait and stop it after 10 min and then try and restart it if it buzzes and rattles bad motor.
It is most likely a blown thermal fuse located on the blower housing next to the heating element caused by restricted exhaust vent on the drier. Check the vent and clean it out if plugged up it will not stay running.
