Singer 5050 Mechanical Sewing Machine - Page 2 - Answered Questions & Fixed issues
The needle moves up and down and the presser foot is lowered (and attached properly) but the fabric is not being pulled through.
Yes, there definitely could be something wrong, but there are some things you should check. Most machines are capable of raising and lowering the feed dogs; yours might be fully or partially lowered, so that while it moves, it's not far enough up to the surface to move the fabric. Using the lever or dial, LOWER it all the way, then RAISE it all the way, but you're not finished. It will still not raise until you turn the hand wheel TOWARDS you (ALWAYS towards you on every machine) at least one and possibly two revolutions. You'll then SEE and most likely HEAR it click up. I know someone who got a steal on a Brother marked defective because the feed dogs wouldn't raise, so she brought it home, turned the hand wheel two revolutions, and viola! The feed dogs raised!
1/22/2014 5:21:17 PM •
Singer 5050...
•
Answered
on Jan 22, 2014
•
195 views
Problems threading the bobbin, the motor is running but bobbin doesn't move
Most likely its the bobbin winder tire, under the lid, where you put the bobbin to wind it. Depending on the machine you have, it can be accessed by the side panel or possibly the top. On the right side of the machine, there should be a couple screws that will need removed, (make sure you unplug it first), and the panel will come off and you should be able to see the rubber ring from there. If not, then, you may have to take the top off to access it, in the same way. Once you have access to the ring, just pop it off and replace it with a new one. If the old one was worn, then, when you engaged the "clutch", it wasn't "catching", in order to spin. When in doubt refer to your owners manual, or paper work that came with the machine. It usually gives a break-down of how all the parts are arranged, and might simplify/clarify, "things" before you start. Hope this helps.
1/13/2014 11:33:43 AM •
Singer 5050...
•
Answered
on Jan 13, 2014
•
80 views
Replacing timing belt
Replacing timing belt. If the feed dogs still move up and down and back and forth then you just need a timing adjustment . If the feed dogs do not move at all then you need a new timing belt Hope.
11/22/2013 4:16:59 AM •
Singer 5050...
•
Answered
on Nov 22, 2013
•
397 views
Shuttle line
Please see the shuttle timing. And change the bobbin case.
11/21/2013 9:56:40 AM •
Singer 5050...
•
Answered
on Nov 21, 2013
•
41 views
Timing belt
Timing of the machine is done by loosening the screws on the gears to move the hook such that the tip of the hook is above the eye of the needle when the needle has risen 2.5mm.
11/18/2013 1:05:35 AM •
Singer 5050...
•
Answered
on Nov 18, 2013
•
53 views
Think bobbin is broken
if the bobbin is broken or damaged then just replace it, with a new bobbin , having several bobbins is always a good idea.
9/28/2013 6:42:54 PM •
Singer 5050...
•
Answered
on Sep 28, 2013
•
27 views
Manual for Morse 1550
check with this website and see if they can help youa1sewingmachines.com,, go to the contact us section, there is a email and a phone number
9/18/2013 4:20:40 PM •
Singer 5050...
•
Answered
on Sep 18, 2013
•
184 views
Not finding what you are looking for?