20 Most Recent Copystar CS-1620 Copier - Page 6 Questions & Answers

Hello sir; I don't know which machine you have, usualy they have paper separetion roller or separetion pad replace it ,will be ok.

Hi there,

Do unplug the unit for at least an hour, this can help you reset the unit. Or you have to clear out the memory by accessing the fuse on the power board, you have to remove it to reset unit.

Make sure that your printer was not plug into elec outlet before doing this.

Hope this helps

Either a problem with the document feeder or something on the glass. If it's faded it may just be a roller not pushing the paper onto the scanning area properly.

Hi there

I think you might mean how do you ping the IP address of the copier? Please confirm.

If so, do you know of the IP address already? If so, go to Start > Run (or in Windows Vista just type:) > type in CMD, and press OK (or in Windows Vista press enter).

A black windows will appear.

Type in ping 192.168.1.1 (or whatever the IP address is).

If you are unsure of its IP address, let me know, and also what Windows you are running.

Thanks.

Best regards

Hi

I believe this issue comes from different color settings used on different computers and different versions of windows.

the solution would be to have the computers all use the same color management settings.

Its not a fault on the printer, it comes down to setting differences. If you prefer a document one way you should print it from the computer where it prints the one you want.

or compare the color management settings under both computers in the printers properties (start -> control panel -> printers -> right click printer properties)

www.klingamans.com

this problem will only occur if the main charge is not working.
it will almost certainly be the whole main charge assembly but maybe the high voltage transformer (but that would be very uncommon)
please rate if this fixes your problem

Hello sir; I believe your error code should be C030, if that's correct that 's mean main board is bad , it not worthy to repaire it, go buy a new machine.

H4 means the heat rollers aren't functioning. It could be thermistor replacement. You can get fuser parts at precission roller.com if you want to fix it yourself.

it sound like the fuser might be bad in the copier

You will have to call a CopyStar dealer or a Kyocera-Mita dealer to get that part.

You probably need a new fuser.

C710 Toner sensor problem
• The sensor output voltage is outside
the range of 0.5 to 4.5 V during toner control.
• The toner sensor control voltage cannot be set within the setting range when maintenance item U130 is run.

Try removing and refitting drum and toner.
If that doesn't help the toner cartridge or sensor is damaged.
Please take a moment to accept and rate this solution accordingly.
Thanks,
Lee

precision roller $ 24.00

http://www.precisionroller.com/k_copystar_cs1810_toner_cartridge/m119d3490c36/

ok this is a fuser error.
you need to try a fuser reset.
key in 1087 1087 then 163 start, press EXECUTE then start again.
the machine will turn off and back on if this does not fix it you need to get a service person.

No money ever! There is no payment made for answers on Fixya, points don't mean prizes, they are just for fun. ADMIN Andrew

• Answers: 65,820 and not a penny per Answer.

Head over to www.justanswer.com they pay lots of money because they charge for people to ask a question. ..