20 Most Recent
GE WBSR3140DW Top Load Washer - Page 3 Questions & Answers
Clothes stuck under agitator
I would try to get clothes out, even if destroyed first. Otherwise,
there is a plastic cover cap on the top of the agitator. remove
by unscrewing or prying off. Hold down nut is exposed and remove
carefully, gently and with a ballanced pry up from underneath to raise agitator.
Why ge washer not spin or agitate?
Check to see if any power to that outlet to see if you have some power by plugging in a light or other electrical device. No power? check circuit breaker for Washer electrical outlet. If it pops back, you have a short somewhere. Unplug washer then try circuit breaker again. If the circuit breaker stays on, you have a problem in the Washer. Call Service man or may be cheaper to find a lightly used replacement, or buy new.
My ge washer pumps the water out but does not spin
If you are lucky the v belt on the bottom of the washer is loose or broken, or the tensioner is not working. If the Agitator works, but not spin your transmission is in trouble or motor reversing switch is broken.
My washer wont fill up orturn on
First test the outlet your washer is plugged in to..it is likely a ground fault interrupter outlet that may just need to be reset. You can try plugging a known working item such as a small lamp or power tool into the outlet your washer uses to make sure it is working. If the outlet is dead and does not have a reset button, Check your circuit breakers.
My washing machine will drain an spin but will not
There is a good possiblity that the agitator coupler is bad. reach into the machine and try to spin the agitator. If the whole thing spins then you have a bad coupler. Some agitators are a two piece design and the top half is supposed to turn freely one direction and catch the other. if you have that type and the top spins both ways but the bottom stays still you have a bad agitator. To remove agitator, grab the bottom and pull up hard. Its only held on by plastic fingers
My washer fills up with water but that's all it does what could be the problem
Lots of suspects? but most likely I would say the water pressure switch diaphram is bad, u can test it by removing the small hose that goes into ( its inside the panel usually) and then have the washer on wash mode and blow into the pressure switch. If it starts washing the diaphram is good but it may still be bad circuit wise electronically speaking, A test with multimer is needed, to test curcuits, ( However if the pressure switch does nothing after blowing into it u have a bad diaphram hence a bad switch. , if it starts washing physically the pressure switch seems to be doing what it is suppose to do. Other culprits a bad door switch, a bad motor switch, and oh oh a bad timer but lets hope not.
For a king size bedwill colossal size wash a quilt
yes I would say these machines will wash this item
should be gentle cycle and max water level settings.
I can confirm kenmores xtra capacity machine does.
If material is delicate or fragile any, the large frontload
machines at local laundromats will be appropriate for this job.
hope this info will be helpful, PAUL Douglas Calif.
How to remove clothes stuck under agitator
the agitator should pull straight up, you may have to twist it back and forth as you pull upward. when you put it back on make sure its all the way down and in place, this may be the reason your clothes are getting stuck under it.
WHY IS WATER LEVEL LOW CAN I CHANGE THE SETTING ON WATER
there should be a knob on the control panel showing small, medium, large maybe even super. that is how you change the water level. Its for different amounts of clothing your washing at a time. If you put in a few clothes then you have the option of using less water.
Not finding what you are looking for?