20 Most Recent GE Profile PDW8400J Built-in Dishwasher - Page 8 Questions & Answers

If it is electrically activated, it is probably a loose wire from the timer control or possibly a bad timer switch.If it is mechanically activated, it may be a broken plastic part in the actuator or at the door itself. Good Luck..

Try this youtube video .... each manufacturer has quite different ways to remove the wash spin arm to get to the filters ... https://www.youtube.com/watch?v=7jW0de4HmVM Helpful??

Those beeps are a fault code. - check the service manual for what to do next,

Probably need to replace door latch / switch assembly

Could that possibly be a GE Dishwasher with a slightly different model number?https://products.geappliances.com/appliance/gea-specs/GDF630PGMWW

u can start by looking and checking all hoses going in and out of dishwasher. usally not hard to locate sometimes a clog will back water up the spout and cause the leak message

If there’s a thermal fuse, replace it.

What is model #?

Keep trying.

may be hinge or spring cable hinge https://www.youtube.com/watch?v=J9vqr4L8StY spring cable https://www.youtube.com/watch?v=6calYe1J6Ps

It should just start up when the power comes back on. If it doesn't, then reset the control and start it again.

Unfortunately, in any way, when we ordered a kitchen from the guys https://nyfurnitureoutlets.com/ then they also wanted something dishwasher to be portable, but they all unanimously said that they quickly break, so get a better new built-in.

motor hums indicates a faulty start/run capacitor get in an electrician for a proper diagnosis