20 Most Recent
Sharp LC32D44EBK 32 in. LCD TV - Page 5 Questions & Answers
How do I stop the green light from flashing Sharp 46 aquos
Remove Main's plug press Input & Ch.Down button from LCD and put Main's plug to start LCD.
You will get K on Screen press Vol - & Ch- from LCD
You will get 1/10 page go to 9/10 by pressing ch.- button
You will get EEP off screen press ch- button from remote and press
Right side arrow from remote and press OK
On screen you will get EEP running.
After finish this oprestion remove plug and restart LCD.
11/28/2014 11:19:22 AM •
Sharp LC...
•
Answered
on Nov 28, 2014
How do I turn the TV speakers off on my Sharp LE 920UN television?
Look in the setup menu for the audio output option. On my menu system this is a sub menu under 'input terminal setting' for System Options. Change the 'Output Select' to 'Variable' which will disable speaker output and enable volume control of the audio out terminal on the back panel. If you have a receiver, you'll run all you audio through the receiver and can just turn the TV speakers off (variable) and forget about them....
11/27/2014 8:11:59 AM •
Sharp LC...
•
Answered
on Nov 27, 2014
How do I do a Reset of my Sharp Aquos LC70LE847U?
These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.
To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; check the site linked above. Pull up older posts. Surf the site with patience.
Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.
9/14/2014 3:50:01 PM •
Sharp LC...
•
Answered
on Sep 14, 2014
Not finding what you are looking for?