20 Most Recent Yamaha 2006 VK Professional - Page 4 Questions & Answers

Google 2004 Polaris frontier touring codes and click on Manual listed.

Could be a bad cdi box. Ive this problem with my xlt when I go for a ride, stop to eat and head back out to go home it won't start. I've usually had to choke it, and pull until it starts. My issue is carb settings. If you don't have spark I'd try replacing your cdi. If you know someone with the same sled try there's.

Problem has to be in the coil now. Even new parts can fail try switching plug wires first. You might get lucky and the wires were just crossed from the one you replaced.

I've owned many polaris snowmobiles and to me it sounds exactly as the current owner states. It probably needs the carbs thoroughly cleaned, taken out and apart. I would also get new plugs as well. I prefer ngk plugs for my sleds. If you've never done it there ate plenty of you tube videos on how to clean and adjust the carbs.

Bowl float is sticking open.
Turn the fuel on tap the carbbie bowl. With something ie end of a screw driver etc... your trying to get the float to unstick. Before you put it back together. ..ie putting the bottom on make sure the float goes up and down freely

failed electronic part in ignition or sensor internal component overheating and breaking the circuit until it cools down

standard carbys will cover a .020 oversize bore melted piston is from detonation which is lean mixture or incorrect ignition timing the oil will be a metered amount so it will be correct for all rpm items like incorrect float level and air filter are the suspect causes

Check the fuel pressure.

Did the shop clean, set, and synchronize the carburetors? Did you check the compression on all cylinders?? (>120PSI on each).. What about the air filter/intake system,,, make sure its clean and clear.....

read your owners manual ... it will tell you...

This is an uncommon problem. There does not appear to be a scree flip setting in the menu. You could try for a reset of the set but I suspect that would do nothing except require you to retune your channel settings. It is possible that the set was jarred or some vibration occurred that cause a loosening of the ribbon cable to the timing control (TCON) unit in the set. One could try resetting that ribbon cable. Otherwise, the fix might involve replacement of the main board. The video settings menu controls do NOT offer control of the screen flip. Here is a service manual for a Sansui 32 inch HD. SANSUI HDLCD3200C Service Manual That would leave you to tapping Sansui support if this information doesn't suffice. Support

I can't see the "box" you are referring to! It is cardboard, or made of wood, or plastic, or steel, or aluminum, or some other material?

I think on a worn startermotor. To be sure, give a little knock on the startermotor end when it won't start. If then it's good starter, then its the startermotor. If still not good, replace your battery.

Oslo Winter Park is just 30 min from downtown Oslo with some incredible slopes!!http://www.visitoslo.com/en/product/?TLp=12087&Oslo-Winter-Park

Reduce the idle RPM.

As far as I know, sleds have two directions. Forward and reverse. To make it go in the opposite direction, push it in that direction, or turn it completely around. God bless your efforts.

According to the specs it has carbs and auto oil injection.

Ski and snowboarding gloves protect your hands from both the cold and ski/snowboarding related injuries.

Clean the engine with a pressure washer and then run it and id the leak, no quick fix for this type of problem.