Arctic Cat 2006 F6 Firecat EFI Sno Pro - Page 6 - Answered Questions & Fixed issues

blockage in the main jet overhaul the carby

You have dirt in the carburetor jets and or passages, clean the fuel tank and rebuild the carb.

Are you asking how to replace the drive belt or where to purchase a new one?

check spark, check fuel, are the plugs wet, does it start on spray starting fluid?

2016 model with low miles on it take it back for a warranty fix

check for the throttle cable adjustment or jammed in a fast speed spot

if it is a 4 stroke engine then the compression is too low and there has to be an investigation as to why blocked air filter would be the first place , then worn rings would be next

I would guess you have a broken spring. Find the one that is broken and replace it.

If you mean track tension, I raise the back of the sled and tension it until it is tight against the sliders in the front, but you can pull it away with 10-15 pounds pressure with your hand.

I have one just like that and yes I think they are all three cylinders. At least mine is.

Normally the pins and bushings get worn on the cams. You should replace them before they get too bad.

They are social animals. The silverback is the chief. Females nurse their young much like humans do.

I always use WD-40, it lubricates and also will burn, easier on the engine than starting fluid.

How is the belt? If belt is wore it will tach more. Maybe your driven pulley is not expanding properly, which lets the belt fall down into it changing gear ratio.

Take your serial # off the tunnel to a dealer. They should be able to tell you. You may even be able to find a website that has a chart.

Bad coil, crank sensor.

Is the clutch halves on the engine moving together when engine speed is increased? If so then I would look inside the chain box, maybe if you're lucky you just broke a chain. It should be real simple to find this, raise the back of the machine off the ground, have someone turn the driven pulley and see where (in the drivetrain) it stops turning.

Sounds like the alternator is bad.

go to answer questions and press all unanswered

Starter solenoids have the tendency to just stop working. Yamaha is notorious for going through the more frequently than any other manufacturer.