Top 20 Yamaha 2013 WaveRunner FX Cruiser SHO Questions & Answers


Must be some obstruction in there. Probably just before the water pump of just after.

Yamaha Boating | 64 views | 0 helpful votes


Look for a plate on the shaft. If not call west marine

Yamaha Boating | 50 views | 0 helpful votes


Two things depreciate faster than a car and they are boats and rvs. A vintage yamaha is a nice term for older yamaha. I will be worth what someone wants to pay for it. That said, if parts are still available and it runs well, no work needed, you may get $1000 to $2000 for it. But that depends on the area you are in and what other used ones are going for. All you can do is offer to sell it for some amount of money and see if anyone calls. Lower the price if no takers.

Yamaha Boating | 64 views | 0 helpful votes


Yamaha would be a possible source.

Yamaha Boating | 64 views | 0 helpful votes


Most likely, (1) it's an old worn out battery, low charge, poor or corroded cable connections. Inspect and clean them. You may want to jumper battery with your car battery. If problem persists, (2) check starter solenoid connections and output connections. (3) As a last culprit, it could be a bad starter. And make sure your engine is not frozen. (Take spark plugs out and turn the flywheel by hand).

Yamaha Boating | 62 views | 0 helpful votes


I believe the P65 is a small engine with 3.5 hp.

Yamaha Boating | 65 views | 0 helpful votes


Not a problem if 1 drops below 60 issues will start. Put 5 oz of marvel mystery oil in the cylinder to help free up the rings. Pour in turn over engine do not start. Let sit over night.

Yamaha Boating | 85 views | 1 helpful votes


I got this free Pdf manual from reliable-store. com for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

Yamaha Boating | 72 views | 0 helpful votes



I got this free Pdf manual from reliable-store. com for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

Yamaha Boating | 72 views | 0 helpful votes


It should have a rubber hub pressed into the prop. It can go bad and is in place of a shear pin. The rubber hub should allow the prop to turn at idle speed but will slip at higher speeds. You can get a new hub pressed into the old prop.

Yamaha Boating | 82 views | 0 helpful votes


It is better to use gas with no ethanol as it can degrade your fuel lines. Also Ethanol is hydroscopic, it attracts moisture and sucks in moisture from the air when you winter store. If you do, then you have to use stabilizer over the winter.

https://www.google.com/search?q=ethanol+fuel+line+damage

https://fuelandfriction.com/weekend-warrior/why-use-fuel-stabilizer

Yamaha Boating | 84 views | 0 helpful votes


Either fuse, switch or pump itself. See your friendly mechanic

Yamaha Boating | 83 views | 0 helpful votes

Not finding what you are looking for?
Yamaha 2013 WaveRunner FX Cruiser SHO Logo

0 questions posted

Ask a Question

Usually answered in minutes!

Top Yamaha Boating Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Mike

Level 3 Expert

4369 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Yamaha Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

WaveRunner FX Cruiser SHO Yamaha

  • WaveRunner FX Cruiser SHO Yamaha

Most Popular Question

need bolt specs 98 yamaha lx1200 put

  • Boating
Loading...