20 Most Recent Yamaha 2011 WaveRunner FX Cruiser SHO - Page 9 Questions & Answers

solenoid is bad.

2 ways... either cut it or remove elec box and disconnect it.

Yamaha did not make the GP model until 97 and if the numbers you posted are correct you have a 94, that being said all yamahas up until 93 were either a 500 or a 650 so im guessing its not a superjet which is a standup so you may have a waverunner 3, Raider, Blaster, or a wave runner LX. What colors are on it? does it have twin carbs? there will also be a sticker on the engine cases noting engine size.

If your talking about the HIN plates on watercraft and vessels then the last 2 numbers will give you the year of manufacture.

right rear under the back seat.

http://us.yhs4.search.yahoo.com/yhs/search;_ylt=A0oGdNefxx9OSV8AZAKl87UF;_ylc=X1MDMjE0MjQ3ODk0OARfcgMyBGZyA2FsdGF2aXN0YQRuX2dwcwMwBG9yaWdpbgNzeWMEcXVlcnkDIGdwNzYwICB3YXZlcnVubmVyIHNlYXRzBHNhbwMx?p=+gp760++waverunner+seats&fr=altavista&fr2=sfp&iscqry=

Hey Kenton Plett,Directed from another answer:You have a bad starter bendix. It is a one way clutch wit a gear on it that moves on the starter armature to engage the flywheel. It is sliding over and engaging the flywheel the way it is supposed to, except, under load it is slipping. Since it is bad you will need to replace it. If it comes off with the starter it should be easy. If it is inside the engine, you may have to pull the engine to take off the cover and replace it. Good Luck

> can anybody answer this ? Yes, your local Yamaha water-sports retailer can answer it.

disconnect battery , remove red and black wires on starterthen remove the top 2 bolts on starter and 1 or 2 bolts at bottom , pending which model but it should come off now !

clean your carbs etc !! fit a water fuel seperator inline from tank to stop problems !

have you got water in the crankcase ? remove plugs and crank and see if water comes out ! if yes then you must keep cranking till all water out the clean plugs and get running asap !

does fuel pump bolt to side of engine and take pulse pressure to feed carb ? diaphram could be leaking etc !

compressions ok ? 100psi min !

do you mean as soon as you press the starter or connect the battery the starter motor turns and wont stop till you disconnect the battery ? if yes then starter solinoide stuck ! replace !!

clean carbs and fuel pump and check diaphrams are soft !

was it the pee tail water that stopped ? try blowing compressed air back in it ! is the exhaust plate on the side of engine getting very hot ? have you checked the thermostate opens in a cup of hot water ?

could be rings or valve seals etc ! strip b4 it fails !