20 Most Recent GE Spectra JBP78 Electric Kitchen Range - Page 4 Questions & Answers

There is something called a surface burner switch that could cause this. Part Number Here..

Which element is it? Try to switch the infinite switch from another element. This will tell you if it is the element or the switch problem.

Hi n5my ,

F1 =  Electronic oven control failure  
Sol. Replace electronic oven control (also called EOC or clock).

The "F9" error code means the EOC (electronic oven control) has found the lock motor switches to be out of sequence or shorted.

Test switches and if there is nothing wrong then replace the EOC.

both of the error indicates the problem in EOC.

Regards
R.K.

F2 indicates that temperature inside the oven has gotten to high. The sensor should read around 1000 ohms at room temperature if not it is bad. Here is the part to order.

You will need to replace the surface element switch. Here is the part to order. Below is a video to show you how to replace the switch.

You will need to replace the control board/display since the oven switch is built into the control board. Here is that part to order.

F2 indicates that temperature inside the oven has gotten to high. Pull the temp probe and check to see if it has 1100 Ohms. If it does, you will need to replace the control board.Here is the probe to order if it is bad.Here is the control board to order if the probe is good.Keep me posted!

Replace the surface burner switch. Here is the part to order.

Look at this video.

See if this video helps you.