20 Most Recent GE JKP20 Electric Single Oven - Page 8 Questions & Answers

sounds like a faulty thermostat

Push the clock button until the colon between the hours and minutes starts to flash. Use the up and down arrow buttons to set the time then push the clock button once again to make the colon symbol go solid.

f3 is a shorted sensor and f5 is a bad computer board or clock assy. same thing http://www.appliancehelponline.com/generalelectric.html

Usually, This means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be canceled, replace the oven control (also called clock or ERC), touch pad, or both.

Does this stove have fuses . if so one or more could be burnt out.

It sounds like you are going to need a control board. You can look for a used one online part number WB27K5210. You can also send your board in to be rebuilt. Corecentrics and Fix your board are two reputable companies.

sounds like you got a defective element

https://www.youtube.com/results?search_query=removing+GE+profile+JT915+27"+wall+oven click on the above link and see if these YouTube videos help

try looking at this... https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Range-Stove-Oven/11-3-616678-/new/GE-Oven-not-heating-JT930SH1SS a call to them may resolve any questions you have. best to you hope this helps a little...sorry for late reply.

Igniter is OK. Check your furnace heaters^ if they're congested with waste then they will automatically turn off.

Check fuses.

Google GE electric oven Model number: ? Manual

Once started you can't

from the serial # it was made in september the second letter N is either 1956 or 1972. take a look at this site it'll lead you to ge heating elements see if there is one that resembles your's. then call them. they are very helpful and may be able to tell you where the model # is. ask if what you're seeing might fit. here's the link... http://www.appliancepartspros.com/ge-wall-oven-heating-element.html Hope this helps a little. Happy New year

Press the oven light switch in and see if the it returns to normal. The oven light switch is part of the self clean circuit and it is is not depressed or not working then it could be the entire problem. If pressing the switch in cures the problem, then the switch is working fine and the clock oven control will need to be replaced. Happy New year and have a wonderful day. Oven light switch part number WB24K10068, Oven control part number WB27K10319. when changeing out this part you have to remove the overlay with button description on it and transfer to new clock, try gentel heating it before trying to remove or the paint will rip off and you will need a new overlay here is the part number just in case WB27K10408

350 is an average of temperature. So your thermometer is not going to read that, it is reading actual temperature. So to get the average, you must use five cycles not counting the preheat cycle. turn the oven on, when you here the first click you then can start recording five clicks of the relay after that , the temperature will got way up and way down, so you should have five lows and five highs, then you average to get the set temp. All manufacturers allow a 25 to 50 degree range of error. In your owners manual you will find calibration mode and how to preform it. I would advise not to go changing it all gung ho and trying to remedy a temperature difference. Small increments of 5 degrees and give it a try. Good luck and Happy baking.