20 Most Recent GE JKP20 Electric Single Oven - Page 10 Questions & Answers

More than likely you have a control circuit board failure.

The "Clean Oven" aspect has been activated and it locks the door. If the door wasn't completely closed when the "Clean Oven" was initiated then that means it is still active. try pressing the"Clean Oven" button a few times to see if it will reset the locking mechanism. This usually fixes the issue you are having. Hope this helps.

http://products.geappliances.com/appliance/gea-support-search-content?contentId=19655

60 amps 220 volt.

Ask once and wait.

Basically you unplug the oven and remove the back, you should see two wires connected to the elements where they come through the oven wall in the back. Unhook those wires. The elements are held in place with nuts on the portions that poke through, remove the nuts and pull the element out through the front, and install the new one. Note that if you break one of the connections on the wires to the heating element, they can be a real chore to repair because they are high heat connections.

There is a sensor/switch that sends a signal that the oven door is locked and that it is unlocked, it must be defective.

That is not a valid model number, the issue is most likely the thermostat has failed. The part is about 12 dollars.

SOUNDS ,LIKE THE BRIOLER ELEMENT BURNED OUT , U CAN TEST IT WITH A MULTI METER. SEE PICS

I don't know. Sounds like an electronic control panel issue/fault. Here's GE's FAQ site. http://www.geappliances.com/ge/service-and-support/faq-ranges-ovens.htm