Top 20
Kenwood KM800 Major Classic Stand Mixer Questions & Answers
Kenwood prospero km262 stopped working
In my case, capacitor C1: 470nF (on the circuit board) proved to be the cause. It measured only half its normal value. It's part of a voltage divider used in place of a transformer. Replacing it solved the problem.
Came already across the same problem in another circuit.
Hook stuck in kenwood major;
Force it out carefully. One person wrap tea towel over hook and turn forcefully, anticlockwise. Secnd person use a long handle screwdriver to hold the Kenwood still - wedge between the housing where the hook inserts. Hold Kenwood still whilst twisting the hook. When it comes apart, clean 'hole' and hook shaft thoroughly with WD40 / oil. Might need new hook if too damaged. Ours is ok seemingly.
I have a Kenwood Chef
Send me your email address and i will send you some info on how to repair it with modern components........... very easily done.
Send to bisley_bullet49 at hotmail dot com
Hello, I have a Kenwood
it will be stripped gearing causing this to happen. The gears are made of nylon so upon getting stripped out you will not hear any noise from it to tell you that. If they were made of metal the noise would show when running
Want to by a kenwood
Try Amazon
hereor if not in UK
hereI hope I have been of help but please do not hesitate to ask if you have any further questions.
I appreciate your vote if you appreciate my reply.
I have a Kenwood Major mixer that gives off smoke
hi its not necessarily the motor but could be some capacitors on the speed control unit ( the control knob is attached to it) spares are reasonable to buy .you can find a dealer from kenwood.co.uk website..
I have a Kenwood
I have a Kenwood Chef A701A. I cannot find where to insert the mincer & grinder attachment.Can you help?
Not finding what you are looking for?