20 Most Recent
Black & Decker 9074CTN 3.6 Volt Screwdriver - Page 6 Questions & Answers
When I attempt to pump the jack up it will not
Either the pressure release valve is loose or the seals are worn out. Make sure the screw valve is tight. If that doesn't fix the problem, buy another jack. The seals really aren't user replaceable.
10/15/2013 3:56:57 PM •
Hand Tools
•
Answered
on Oct 15, 2013
I want to register my
go to the manufacturers site and see if you can down load a pdf file or see if you can enter the details direct
8/2/2013 9:55:06 AM •
Hand Tools
•
Answered
on Aug 02, 2013
HT power coil jumping
Remove the HT lead and clean around the area with a good electrical contact cleaner. Look for cracks in the insulation around the HT lead. Replace the Boot around the lead or replace the lead. Clean out the inside of the terminal. The spark is tracking down some dirt/ moisture or crack. If the coil is cracked replace the coil.
8/2/2013 9:42:26 AM •
Hand Tools
•
Answered
on Aug 02, 2013
Find strut compressor tool
This tool is available from good auto spares stores make sure by 2 as they have to be either side of the spring and good quality as your fingers will be damaged if poor quality ones slip
8/2/2013 8:10:19 AM •
Hand Tools
•
Answered
on Aug 02, 2013
Loppers stuck
You can try loosing them off a little and use some lubricant as well say spray lithium grease or wd-40 or crc.
8/2/2013 8:06:30 AM •
Hand Tools
•
Answered
on Aug 02, 2013
Burgess Vibro-tool Deluxe
Between the set screw and the bit. Use pliers to unscrew. U may need to hold the bit so it does not burn at the same time. Just like a drill :)
5/11/2013 8:01:36 AM •
Hand Tools
•
Answered
on May 11, 2013
Air hammer
Need more details as to whats not working.
5/6/2013 1:13:32 PM •
Hand Tools
•
Answered
on May 06, 2013
Not finding what you are looking for?