20 Most Recent
RTO Paslode 902000 IM250 Ii Cordless 16 Gauge 3/4 2 1/2 Inch Straight Finish Nailer - Page 8 Questions & Answers
How do you change the bit on a black and decker 5/8 router
in wood. The tool consists of a motor that drives a cutting bit; the bit spins quickly and cuts the wood. The router can be moved horizontally through the wood to form a desired shape, and the type of edge on the shape is determined by the design of the router bit. Different edge designs can be cut by changing bits. It is very easy to change the bit on a Black & Decker router.
Step 1
Turn the router off and ensure that it is disconnected from the power supply. Wait for the router bit to cool down if it was recently used.
Step 2
Detach the chip shield from the back of the face plate.
Step 3
Depress the spindle lock button on the side of the router and rotate the spindle until it locks.
Step 4
Turn the router upside down and place it on a flat surface.
Step 5
Keep the spindle lock button depressed and loosen the collet nut that holds the bit with the spanner wrench. The collet is the device on the router that holds the bit in place.
Step 6
Remove the bit and insert the shank of the new bit into the collet. The shank should protrude at least 1/8" from the collet.
Step 7
Keep the spindle lock button depressed and tighten the collet nut with the wrench.
Step 8
Release the spindle lock button. Reattach the chip shield.
What Refills should I use for the pop 2000 stapler gun
The ARROW #506 T50 staples work perfectly. I've used both 3/8 and 9/16 sizes. They are on Amazon at
https://www.amazon.com/Arrow-Fastener-50624SPTP-T50-Staples/dp/B001KOVZQ8/ref=sr_1_5?crid=3FR4QFTDVRY37&keywords=arrow+t50+staples+3%2F8&qid=1636149518&sprefix=arrow+t50%2Caps%2C176&sr=8-5
Belt sander adjustment
There should be a knob on the front of the sander which adjusts the front roller on the sander. If the belt runs off in the same direction each time try turning the knob as the sander is running and while watching the belt. If turning the knob one direction does not work try turning the other direction. If turning the knob does not have any affect on the way the belt tracks on the sander then you probably have a broken or missing part on the front of the sander. This may require taking the sander to a service center.
Mastercraft rotary tool not turning on
Did you blow a fuse, or trip a circuit breaker? Often an overload like a stuck motor indicates there is a circuit being opened. If you know how to get inside, check the brushes, but I am inclined to suggest looking at a possible fuse blown in the power circuit, possibly in the power strip you use to plug in multiples.
Not finding what you are looking for?