20 Most Recent Eurosled Snow Shuttle Deluxe Sled Kids , Blue - Page 5 Questions & Answers

Check compression if it is low then you will have to pull head anyway so you may as well have a look/see!

Did you try laying the plugs on the head and plug them into the wires, then crank it over and see if the plugs spark then. If they don't then maybe crank sensor or cdi box is bad.

Check the compression on the engine, maybe losing compression?

Is it getting hot?

Check the wire coming out of the sensor to ground with an ohm meter, as the motor warms up, it should change. If it doesn't its the sensor, if it does its either the gauge or the wire going to the gauge.

Did you try changing the spark plugs?

Some modles are actually located under the engine. follow your spark plug wires back,they will end at them! lol

blockage in the main jet overhaul the carby

Are you asking how to replace the drive belt or where to purchase a new one?

You have dirt in the carburetor jets and or passages, clean the fuel tank and rebuild the carb.

check spark, check fuel, are the plugs wet, does it start on spray starting fluid?

2016 model with low miles on it take it back for a warranty fix

check for the throttle cable adjustment or jammed in a fast speed spot

if it is a 4 stroke engine then the compression is too low and there has to be an investigation as to why blocked air filter would be the first place , then worn rings would be next

I would guess you have a broken spring. Find the one that is broken and replace it.

If you mean track tension, I raise the back of the sled and tension it until it is tight against the sliders in the front, but you can pull it away with 10-15 pounds pressure with your hand.

I have one just like that and yes I think they are all three cylinders. At least mine is.

Normally the pins and bushings get worn on the cams. You should replace them before they get too bad.

They are social animals. The silverback is the chief. Females nurse their young much like humans do.

I always use WD-40, it lubricates and also will burn, easier on the engine than starting fluid.