Top 20 John Deere Gilmour Traveling Sprinkler - 4010j Questions & Answers

Go to www.gilmour.com/replaceparts/

the spray bar nozzles can be adjusted to spin the head clockwise or counter clockwise if the wheels run backward rotate the nozzles so the water pressure turns the head in the opposite direction which will then drive the wheels in the opposite direction..

First thing check plug screen. Water coming to sprinkler ok?

They're no longer made. Try ebay.

Go here: http://www.gilmour.com/replacement-parts/And order the spray tube assy TS01521.

Well we start with it is made in china, what did you expect. The gears are worn out may be just junk or a nice lawn ornament now, but the service number for these is 800-458-0107 if you wan to see if they are willing to help you.

Are you sure you are "in gear"? I have beat mine to death ... but it still runs. The gears are pretty tough, but they are not invincible. It is possible you have a stripped gear. If necessary, get replacement parts at your hardware store.

Hi,

Here is a tip about how to get parts foryour traveling lawn sprinkler and also a great article about how traveling lawn sprinklers work.

TravelingLawn Sprinklers

heatman101

Hi, That is typically caused by too small of a hose or not enough water pressure...

Here is a tip about how to get parts foryour traveling lawn sprinkler and also a great article about how traveling lawn sprinklers work.

TravelingLawn Sprinklers

heatman101

The wheels are driven by the spinning of the water wand. Turning the tips so the wand spins either clockwise or counter clockwise will determine which direction your sprinkler will travel. If it's going backwards, turn the tips so the wand spins in the opposite direction it is spinning now.

Its direction of travel is dependent on which way the spray arm spins. Was the arm bent in someway that might make it spin the wrong direction? The arm nozzles are pointed the wrong direction. If there is an adjustment that's where you need to change its direction of travel.

Make sure you are holding the shaft that goes down into the tractor still. You may need a pipe wrench to hold it tight. If it is still stuck you may need to use something like PB blaster to loosen the joint. Gently heating the joint with a propane torch and letting it cool back down might break it free as well.

Make sure your spray arms are both pointed in the proper direction to assure forward movement. It will run backward if the spray arms are pointed in the wrong direction.

Thanks for letting me answer your question this evening ...

Hi,
The gears are going bad and jamming up...

Here is a tip about how to get parts for your traveling lawn sprinkler and also a great article about how traveling lawn sprinklers work.

Traveling Lawn Sprinklers

heatman101

Hi,

Here is a tip about how to get parts for your traveling lawn sprinkler and also a great article about how traveling lawn sprinklers work.

Traveling Lawn Sprinklers

heatman101

';

';
';
';';';';

Improperassembly. Change the direction of the nozzles on the spray bar so it turns in the opposite direction..

If it is new ... take it back to the place you bought it ... see the clerk who took your $ ask them if they remember you purchasing the device on a particular day ... establish that is is a new device then ask for instruction on operating it or for an adjustment or parts to repair it.

Because it looked cool, more then likely you will need to take it apart and fix it, or if you still have the sales receipt exchange it for a new one. Good Luck Tim

Hi,

Here is a tip about how to get parts for your traveling lawn sprinkler and also a great article about how traveling lawn sprinklers work.

Traveling Lawn Sprinklers

heatman101

';
';
';