20 Most Recent Clark Forklift Horn Button Switch , Cat Etc - Page 3 Questions & Answers

usually these are on the end of a Motor, has the motor itself has, jammed. or failed ?

On the right side of the machine open the side cover. Right near the fan on the timing cover is an oil cap. That machine has a flat head continental. There is no valve cover!

So if you have three cylinders then the extend ports of the cylinders(bottom) should go to the 'A side of the valve and the Rod end or retract (top) should go to the "b" side. The A or B are probably not marked. Each cylinder should go to the valve at the coresponding lever.

Hope this helps you ask again for more..WF Services

SAE 90, or Transmission Oil should do the trick

it has bypass in the cylinders you need to rebuild it[put new seals in it].

Is it comming out of the pump? if it is it's a Bear to get to.

FAULT NAME: VMN HIGH - FAULT DESCRIPTION: wrong voltage on power motor outputs, failure in the power section or in the mosfet driver circuit or in the motor. https://www.forkliftaction.com/forum/trouble-code-31.aspx?t=14834 https://errors-codes.jimdofree.com/clark/

Error code -51 on a Clark forklift typically indicates a problem with the hydraulic system. This could be caused by a variety of issues, such as a faulty hydraulic pump, a leak in the hydraulic system, or a problem with one of the hydraulic valves. To troubleshoot this issue, you will need to first check the hydraulic fluid level and make sure it is at the correct level. If the fluid level is low, refill it to the proper level and see if the error code clears. If the fluid level is fine, you may need to perform further diagnostic tests to identify the root cause of the problem. This could involve checking the hydraulic pump and valves for any visible signs of damage or malfunction, as well as testing the system for leaks. If you are not comfortable performing these tasks, it may be best to contact a professional mechanic or the manufacturer for assistance. They will be able to diagnose the problem and recommend the appropriate repairs.

It could be that both the main controller and the secondary controller both need to be replaced here.you might have to replace both of the two controllers then

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Clark GCS GPS Standard Forklift Factory Service Repair Workshop Manual...

Talk to your county clerk office.

Do you hear the groan of the hydraulic system?