20 Most Recent
Bosch Classixx WVF 240S Front Load Washer / Dryer - Page 5 Questions & Answers
I have a bosch nexxt 500 series washing machine . It is filling and draining st same time. What is causing this
It's likely that you have a siphon occuring. Check the position of the drain hose. The bottom of the end of the hose must be above the maximum water level of the washer. In some cases, you may just need to pull the drain hose up and secure it so that it isn't pushed too far down. For other cases, you might need to lengthen the stand pipe by adding a coupler and another length of pipe. (If you have the drain hose going into a laundry sink, you might need to raise the sink if there is no easy way to get the hose secured in a higher position.)
I hope this helps.
Cindy Wells
BOSCH MAXX CLASSIC E2 error reset, has water and drained, but the machine did not run/spin.
FROM FIXYA
Sanja Salatic NOV 29, 2009
The e2 error is a generic error that the machine shows if it's been overloaded or if the load becomes unbalanced during a wash cycle.
to fix you must do a master reset of the washing machine.
1. Close the door and make sure the dial is pointing to the "OFF" function
2. Hold the Start/Pause button and turn the dial anti clockwise (to the left) to the "express 15 min" program at the same time.
3. Hold the Start/Pause button for a minute (the e2 message is meant to start flashing after a minute of holding the button down however with my washing machine this didn't happen)
4. Release the button and turn the dial back to the "Off" function.
5. Select any program and the message should not be appearing.
--------------------------
My Bosch washer shows E18, door will not open .Please help
That error is for too long of a drain time. The machine may still have water in it. You need to drain it and then check the filter and the drain hose and pump. Since you did not post the model number of the machine, that is all I can tell you
Not finding what you are looking for?