Bosch Logixx WFT 2806 Front Load Washer/Dryer - Answered Questions & Fixed issues

It's recommended to call Bosch Customer Support at 1-800-944-2904 and specify the exact error code when calling. Good luck.

My Bosch washing machine shows error code F57 and beeps

Thermal sensor - check and replace

Faulty sensor

Bosch Logixx 8 error code nr0 means - The childproof lock has been activated. Just deactivate the childproof lock.

The door is not locked properly. Open and close the door again and press the "start reload" button (play and pause button). If necessary, open the washing machine door, remove some of the cothing items and then push the door closed again. You can also try switching the washing machine off and on again, setting the programme and then starting the programme.

Bosch Logix with error code F43 has "a motor fault". You can reset the error code by the follow steps: 1. Turn the appliance knob to the off or reset position, 12 o'clock. 2. Turn the knob to the 6 o'clock position. 3. Press and hold the spin button and while holding the spin button turn the knob to the 7 o'clock position. Continue holding the spin button for about 5 seconds then release the spin button and now turn the knob to off When your turn it back on it should have cleared the error code Check motor connector blockCheck wiringCheck motor carbon brushesCheck tacho connectionsCheck motor

I would call the local engineer for a quote as the heating element ma need to be replaced eric

Sump hose has fallen off Unplug tilt machine back have a look underside to check also could be the soap dispenser hose Hole in it.This rubs away on side of machine 5yrs old.

Plane on fire eject eject eject

Turn it anticlockwise if it won't turn it has something inside jamming it you will need to remove the pump and filter assembly and take it apart to clear it

Do you hear the pump starts turning? If yes : some clothing is blocking the hose to the pump. If no: electronical failure i.g. a relais on the programmer board.

nrO is child lock. Hold start button for 5 seconds to remove.

it can be done by yourself as long as you feel comfortable in doing so as it can be a bit fiddly. you will need to unplug the appliance, unscrew the pump housing from the cabinet, disconnect the hoses on the pump housing this will enable you to find the obstruction, remove it and subsequently unscrew the filter. then reassemble

There are usually 3 compartments in the drawer, the smallest is for using fabric conditioner, the largest is where you put the powder or detergent in, the middle size one you do not put anything in, as it is where the cold water comes in for rinsing.
Plz rate my solution.
Thanks.

spray wd-40 on the crack where the lid meets the body and work it back for forth trying to go a little more each time -cheers Denny

This might help you with the pump its on a bosch Please remember to subscribe to our YouTube channel for all appliance tutorials a 4 THUMBS rating is appreciated for answering your FREE question.

WFD2460 Bosch washing machine This video will show you how to keep your soap draw clear and how to service the parts Please remember to subscribe to our YouTube channel for all appliance tutorials a 4 THUMBS rating is appreciated for answering your FREE question.

Possibly a blockage pump or drain outlet, check the filter behind the flap (bottom right on the kick panel).

Power on, press the start button for 5 or 6 seconds, the key sign will go off. Perhaps your machine was accidently locked.Helped?