Bosch Nexxt WTMC 3300 Electric Dryer - Answered Questions & Fixed issues
Dryer is not heating to dry clothes
if its not heating at all, first check electrical and make sure your getting 220 to the dryer if you are more than likely its the heating elements, check them and replace if bad
I cant figure out how to change the light bulb on
You need to go through the top panel with the switches to access the bulb. First remove the screws that hold the top to the dryer. (There are a series of tabs with the screws.) Next, use a flat blade screw driver to push down and pull out the plastic tabs along top of the front panel. Pull the top of the front panel back. Now look for some plastic tubes. Stick a screw driver down into the machine and pry the tubes up at the bottom. Then you can access the light bulb and its socket.
I hope this helps.
Cindy Wells
Dryer does nor heat.
Bit vauge as a problem.not cleaning out lint filter or condenser regualy will cause element to burn out.or thermisters to go short.normally 2 or 3 of them checking temp in /out / if ur very lucky on rear of machine u may find a button that trips out to push.but only some dryers have this
How do you reset the Bosch 500 series dryer?
One has to remove the back panel (need Torx bit). Down by the exhaust vent, there is a small red button (see detailed drawing) and push it to reset. It is annoying but will save a lot of money on a service call.
Does this dryer has a light inside?
Not all dryers have an inside light. Yours may have one though. Do you see a light socket and cover inside your dryer. If so, you may just need to replace the bulb. If not, you nave to just live with it until you get a new one. Unless you are in a dark room, there should be enough to do your drying.
Heat problem
Sound like thermostat is not working. Should turn off heating elements when drying temp. is reached.
Not finding what you are looking for?