20 Most Recent
Epic View 550 Treadmill - Page 3 Questions & Answers
Everything works except the Treadmill motor ? Incline works OK, belt doesn't turn at at all. Model EPIC View 550
1) You have problem with LUBE deck belt, this happen because the lack of maintenance, you must lube EVERY week, use 100% silicone lube. Maybe you have WORN deck belt,2) LUBE the rollers bearing too, use wd-403) Test the drive belt motor, see for break, or worn, and replace or tension by 1/4" 4) Test the input voltage motor, if there are the motor need repair. see my personal TIPS for help and troubleshooting.5) Test the output voltage board, for input voltage motor, if there are NOT the board controllers is faulty. God bless you. see the block diagram attached.
Console epic 550 treadmill
adjust the REED swtich, test it for open or faulty, clean it , and tight the plug very well. see the diagram attached.Plug the ribbon cable for keypads very well, and clean it.God bless you
Treadmill deck will not fold in the storage position
HOW TO FOLD THE TREADMILL FOR STORAGEBefore folding the treadmill, adjust the incline to the lowest position. If this is not done, the treadmill may become permanently damaged. Remove the key and unplugthe power cord. CAUTION: You must be able to safely lift45 pounds (20 kg) to raise, lower, or move the treadmill. 1. Hold the metal frame firmly in the location shown bythe arrow at the right. CAUTION: To decrease the possibility of injury, do not lift the frame by the plastic footrails. To raise the frame, bend your legs, keep yourback straight, and lift with your legs. Raise the frameabout halfway to the vertical position. 2. Raise the frame until the latch knob locks into the storageposition. Make sure that the latch knob is locked in thestorage position.To protect the floor or carpet from damage, place amat under the treadmill. Keep the treadmill out of direct sunlight. Do not leave the treadmill in the storageposition in temperatures above 85 Fahrenheit.http://www.treadmilldoctor.com/?utm_source=fixya&utm_medium=CPC&utm_campaign=Mendi
The motor does not turn on
Dear Sir:This is probably a 1) faulty speed sensor or 2)the speed sensor is not plugged in properly. 3)ts also possibly a faulty motor control board or lower board.+ 4) main motor fault. Adjust the sensor speed see the diagram.Run the software calibration for easy diagnose and troubleshootin.See my personal TIPS for Help and diagnose.sincerely. God bless you.ernesto cuadramanagua, nicaragua. c.a
Not finding what you are looking for?