20 Most Recent
Gmc Dodge Ford Reverse Back-up Sensor Alarm Kit - Page 2 Questions & Answers
Como se activa la alarma de una toyota tundra
tengo una 2007 toyota tundra lumited 5.7,pero no me dieron el cotrol ,solo la llave y quisiera saber si con solo ka llave podria programar un nuevo control con el mismo sisteme de seguridad que tiene
Car security light won't stop flashing while driving?
Are you disarming the system with a remote or disabling by inserting the key. On some vehicles you may have a remote control key fob and a master key that works with no buttons, it is a straightforward key with no buttons that temporarily disarms the vehicles alarm for use, it does not fully disarm. When the alarm system is armed through the remote it can only be disarmed through the remote via the transmisson of a coded signal. Have you got these 2 different kinds of keys?
Please add detail and resubmit the query
Why my 1999 toyota sunroof dont close?
You are in luck...considering the motor sounds means no blown fuses,relays and no burnt out motor...(I have seen this many times with land rovers)...what you have to do is...Be sure your hands are clean.....At the front center of the sunroof is where the motor is..You have to carefully remove headliner/trim from the area ..In front of the sunroof glass under headliner/plastic trim you should see the motor...You will have to pull it down until you can see the motor and the cables that move the sunroof..(Some have a small chain instead of cables)...Have an assistant to operate the sunroof switch so you can see exactly where the cable has came off the round pulley or track...If you can't pry it back on track use a small flathead pocket screwdriver...However depending on the mounting position of the motor it is sometimes more efficient to just carefully disconnect the cable from the motor,put cable back on track then attach to motor..It will be a slight task pulling cable to re-attach to motor..I have had to use very small needle nose vise-grips in order to get the proper grip to the cable..or If you don't have vise-grips try regular but small needle nose plyers...It will be hard to get to because you don't want to pull the entire headliner down..Once you get it together operate the switch and inspect the cable movement to see if there is any unusual reason it came off...Most common reason is hitting the switch accidentally in the wrong direction when open or closed..Or hitting the switch back and forth without looking to verify if it is closed all the way or open...Put all back together if all looks good..I don't think there is a way to adjust the cable if it seems too loose..It is supposed to be slightly loose because too tight would burn up motor..If you can't get cable back on or cable is in perfect position you can easily remove motor to perform the operation...If the cable hasn't came off It means the small gear inside the motor has stripped or came off the pin ...then you will have to remove the motor anyway...If cable is broke you can order a new one..It is hard not to get the headliner dirty...Good luck.."..........Brooks/ Metalpoet...
Starter engages on own
Think this might be ignition switch. Take some wd40 or similar product, spray it into the ignition switch then turn the key to start position couple times, as in off then up to start off up to start, sounds more like the switch is dirty as opoosed to the alarm system.
Not finding what you are looking for?