20 Most Recent
Electrolux Lux 7000 Bagged Canister Vacuum - Page 2 Questions & Answers
Cannot find filter in bag compartment
Hi,
If you're looking for the exhaust filter, it is on the top of the machine under the crevice tool and dusting brush.
If you look at the rear of the machine you will see a tab on the attachment holder.
Remove the attachments on the unit
Push tab on rear of vacuum on the attachment compartment
Lift cover and your exhaust filter should be exposed and should just pop right off for replacement.
Aerus Lux 7000: the full
Electrolux uses a pressure differential control valve. This valve measures air before and after the bag. There is a orfice or small hole where the hose connects to the vacuum cleaner, and a orice at the back of the bag canister. As the bag fills up the suction pressure reduces at the hose connection and increases at back of the bag canister. When this happens the control valve has a diaphram that closes, which shuts the vacuum off and gives you a full bag light. There is a thin plastic flange that prevents an o ring on the control valve stem from coming off. The flange breaks, the o rings comes off the stem and the vacuum will shut down indicatiing bag full. The after market price is about 22.00. The valve is easy to replace if you are familiar on electrolux vacuums. When I replace these valves, I use epoxy two part plastic putty on the flange of the valve. It takes 2 days to cure, but the flange will not break.
How to take cordwinder out of aerus 7000 power cord doesnt retract. so how do i get into the canister where the cordwinder is?
Set the vacuum on the table, bench, etc. on it's wheels, remove the bag and leave the compartment lid open. All internal components are accessed by removing the two rubber side bumpers on either side of the vacuum. This is done by sliding a wide blade screwdriver at the back of the bumper in between the bumper and the plastic rear of the vac and tapping forward with a rubber mallot. Just be careful.After removing the two rubber side bumpers, turn vacuum over on it's back and pull the bottom off but only after pulling about 2 feet of the retractable cord out for clearance. You may then access the cordwinder to replace. I have replacement cordwinders available for you.
I think it's the on/off switch since it doesn't feel right. But I would like to diagnose it before I bring it in for repairs. Can I replace a control switch myself? I can take apart anything!
It sounds like the Rocker Assembly has cracked inside your switch. When they break it's usually in the "Off" position.So this is how you take it apart:Remove HoseRemove BagNow stand the vacuum up and peel back the bumper guards on the left and right side of the vacuum. Peel them back roughly 6 inches and pull straight up on the bumpers. This should release the side of the machine.When doing the other side be careful in doing so because once you release that last bumper, your vacuum will be ready to disassemble.When you remove the bumpers place your vacuum wheels up. Pull the cord out roughly 3 ft, just for slack. Now you should be able to release the bottom of your vacuum.When you lift off the bottom of your vacuum (wheel side) the front cover and the bag compartment will come with it. Just be careful. There will be about 4 wires. Just unclip the wires from the bag compartment. That way you can place the front of the vacuum at the back of the machine to give you more room to work with.When removing the bag compartment, there will be a clear hose that plugs into the lower corner of the compartment. That will just slide off, but be sure when you reassemble that you connect that clear hose back on your vacuum will show a full bag indicator.Now once you have the front cover and bag compartment out you should see the underside of your switch. There will be 2 to 4 screws. Remove them and the cover will release your switch from the underside. When your switch comes out you will have to push the retaining clip on the top of the switch to remove the cover. Once you do that you will see 2 slider switches with a broken rocker in between them. There will be a small spring attached to this rocker so pay attention on how it goes back on the rocker.Go to your local Aerus Electrolux with your rocker and tell them you want a replacement rocker. It should be under $10.00 and once you do that, just reverse these steps.Good Luck!
Not finding what you are looking for?