Kenmore Elite Oasis 27052 Top Load Washer - Answered Questions & Fixed issues

0helpful
2answers

How do I remove agitator?

look for a screw on the top and take it out if the is not one should just lift out if not fixed in
8/9/2022 6:13:20 PM • Kenmore Elite... • Answered on Aug 09, 2022 • 277 views
0helpful
3answers

I make homemade liquid laundry saop and when I use

you NEED to buy real washing soap from a store. I recommend Tide because you may be mixing wrong ingredients or not adding something. If buying new/real soap doesnt work i would go to a sears or email sears at their website and tell them.
2/3/2018 10:20:23 PM • Kenmore Elite... • Answered on Feb 03, 2018 • 311 views
0helpful
1answer

I used my kenmore Elite

Washer Not working at all Symptom Diagnosis Sears PartsDirect The page has tips on what might be the issue. You need the whole part number like 110.27052600 and it could be expensive to repair.
12/14/2017 12:17:07 AM • Kenmore Elite... • Answered on Dec 14, 2017 • 476 views
0helpful
1answer

Kenmore Elite Oasis HE Washer #27087. Doing a load

I would think the lid would unlock once you unplugged the machine. Check your owner's manual for any kind of "emergency reset" procedure. Perhaps the lock mechanism is jammed. Have you tried pressing on the lid or tapping it to see if that frees the lock?
11/22/2017 8:34:56 PM • Kenmore Elite... • Answered on Nov 22, 2017 • 427 views
0helpful
1answer

I have a oasis HD

Probably tub bearings are worn. You can also take Pump off and look to see if any obstructions are there.
11/12/2017 1:28:59 PM • Kenmore Elite... • Answered on Nov 12, 2017 • 249 views
0helpful
1answer

Kenmore Elite Washer Mod 110 27062601 Ser CT

I would still replace the suspension rods and bushings. Not much else it could be if machine is level and clothes are distributed evenly. I also have seen the cabinet weld separate at bottom, so be sure cabinet is secure.
11/4/2017 6:10:33 PM • Kenmore Elite... • Answered on Nov 04, 2017 • 175 views
0helpful
1answer

My Kenmore Elite Oasis Ht Top Load washer has a slow drip from the drain pipe. How to stop?

If not during a wash it is standing water. Remove tube and check for cracks. If so, replace. Does/did the washer "walk"? May have rubbed the discharge tube and caused the leak. Is the down pipe in a cold external wall? May be condensation from humid air hitting cold. If the sound is the problem, attach a string to the drain pipe so water drips directly to side of vertical pipe. washer-nelq4qhinul5odf12inlfvjx-1-0_0.jpg
11/3/2017 6:12:19 PM • Kenmore Elite... • Answered on Nov 03, 2017 • 151 views
0helpful
1answer

Wet Clothes

Change belts
10/28/2017 9:23:32 AM • Kenmore Elite... • Answered on Oct 28, 2017 • 123 views
0helpful
1answer

Washer turns on but does

Depending on the age of the washer most modern appliances cost more to repair than they are worth. Your problem sounds like more than a simple filter. I suggest unplug it, dip the water out of it with a quart cottage cheese cup, then recycle it and purchase a new one.
10/13/2017 11:11:34 AM • Kenmore Elite... • Answered on Oct 13, 2017 • 112 views
0helpful
1answer

Kenmore Elite Oasis Top Load washer - There are

sounds like a gearbox oil seal,which are not normally replacable tie to replace it
9/27/2017 11:54:40 PM • Kenmore Elite... • Answered on Sep 27, 2017 • 364 views
0helpful
1answer

My Kenmore Elite washer model 110.27062600 stopped

if this is an oasis model. Try pushing other buttons you should get a touch tone (beep) as a good response. if no sound you seem to have a interface problem. not a main ctrl.
9/19/2017 10:09:30 PM • Kenmore Elite... • Answered on Sep 19, 2017 • 424 views
0helpful
1answer

The control panel on the

Try wd40
8/13/2017 3:20:06 AM • Kenmore Elite... • Answered on Aug 13, 2017 • 171 views
0helpful
2answers

Error F51 for Kenmore Elite Oasis Toploading

bad main board or motor possitioner sensor.. most likely motor sensor.
China made junk parts with a million problems
5/2/2017 11:46:18 PM • Kenmore Elite... • Answered on May 02, 2017 • 873 views
0helpful
2answers

In mid wash the Kenmore Elite Oasis HE flashes F51 and

check if basket turns freely. if it does replace the main board
5/2/2017 11:42:19 PM • Kenmore Elite... • Answered on May 02, 2017 • 2,480 views
0helpful
2answers

Water is not pumped away, or stops in the middle

Recall the error codes by activating the Automatic Diagnostic Test Mode to determine the cause of the problem. Select any one button, except Power, Start, and Stop, and follow this:
Press and hold the button for 3 seconds>Release the button for 3 seconds>Press and hold the button for 3 seconds>Release the button for 3 seconds>Press and hold the button for 3 seconds

All of the indicators on the console will light up for 5 seconds while 88 is displayed on the Estimated Time Remaining display. If not, repeat the step. Let us know if it cannot be activated.

The program then checks for any saved error codes after 5 seconds. List down the codes and post it back here. The console indicators will turn off then on with the 88 displayed if no error codes are recalled. After 5 seconds, the automatic test begins. The program performs a four-minute automatic test to check major washer functions. Press the same selected button in activating the automatic test above to advance through the automatic test steps.

  1. C0: The motor goes to a slow spin.
  2. C1: Warm water fills through the fresh dispenser and basket floats then disengage.
  3. C2: Cold water fills through the bleach valve for 10 seconds.
  4. C3: Hot water fills through the fabric softener valve for 10 seconds.
  5. C4: Warm water fills through the detergent valve for 10 seconds.
  6. C5: Agitates for 15 seconds.
  7. C6: Recirculates for 10 seconds.
  8. C7: Drains to engage basket and drain further for 10 seconds.
  9. C8: Drains and spins slowly.
  10. C9: Coasts to stop.
  11. Press the Stop or Power button to cancel/exit the test.
Inform us about the result of the test for the repair guide if necessary.

5/20/2023 6:26:27 PM • Kenmore Elite... • Answered on May 20, 2023 • 770 views
0helpful
1answer

How to remove the Lid lock of an Kenmore Elite Oasis He washers ?

Here's a good video that shows you step by step: https://www.youtube.com/watch?v=Nx6tJnyAi0Y
8/27/2016 12:19:44 AM • Kenmore Elite... • Answered on Aug 27, 2016 • 919 views
0helpful
1answer

What does a flashing F51 code mean?

Dump the appliance. sears delivers the worst garbage available
5/15/2016 1:27:45 AM • Kenmore Elite... • Answered on May 15, 2016 • 164 views
0helpful
1answer

How do i access the area below my washer basin/tub?

I surely wish I had good news, but most likely you will have to find & pay someone to completely dis-assemble the washer to do this. If you lived in my area of Florida, I would send you to an older man who knows all there is to know about Kenmore (Whirlpool) washers, and he could tell you if is possible. Do you have anyone in your area who you could ask? Specifically, someone who is older, experienced, and works out of their garage, or small workshop. God bless your efforts.
3/10/2016 9:48:14 PM • Kenmore Elite... • Answered on Mar 10, 2016 • 76 views
0helpful
1answer

Removed inner drum and there's about a gallon of water inside ....is this normal

Carol, that is a little much, mechanism that contorl pump may need adjusted. To show your appreciation press the helpful button and follow me on fixya for more tips and info
4/1/2016 5:06:02 AM • Kenmore Elite... • Answered on Apr 01, 2016 • 78 views
0helpful
1answer

My washing machine is flashing dl. Even if I try to close it it wont work. Even if there is nothing blocking the door. Pls. inform

Have you put too much washing in....pushing against the door mechanism??? Reduce the amount of washing...see if that works..
1/6/2016 1:32:16 PM • Kenmore Elite... • Answered on Jan 06, 2016 • 80 views
Not finding what you are looking for?
Kenmore Elite Oasis 27052 Top Load Washer Logo

1,394 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Alexander

Level 2 Expert

171 Answers

Cindy Wells

Level 3 Expert

6688 Answers

vince

Level 3 Expert

2530 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...