20 Most Recent Stanley Fatmax Xtreme Retractable Utility Knife - Page 6 Questions & Answers

go to www.ebay.com/manual...sp5

satreece,

The only location that you can get service for the Stanley COMPULEVEL is from Technidea Corporation. A standard factory recharge for the Stanley COMPULEVEL 35-100 Elevation Measurement System is $150.00 and includes a thorough evaluation, R&R of the liquid, recharge of the pressurizing gas, testing, cleaning and repackaging, and complimentary return shipping via UPS Ground to all locations in the US and Canada.

An electronics upgrade is also available for your COMPULEVEL, allowing 2X faster and 3X more accurate measuring and significantly more stable readings. COMPULEVEL upgrades start at $195.00, plus the cost of the standard recharge.

For detailed instructions on how and where to send your COMPULEVEL for service, please visit www.ziplevel.com and click on the 'Service' tab at the top of the page. If you would like to upgrade your COMPULEVEL, please include a brief note with your unit when you send it in for service.


Contact information for Technidea is below.



800.805.LEVEL
760.480.4740 Office
760.480.4738 Fax
[email protected]
www.ziplevel.com

The level is meant for 360* of USE not from one single position check both horizontal and vertical... I think that one is a Moveable

Laser? Level?
OH I just found .. is it on a tripod like attachment? there should be a small round "level" on the physical Base of the level itself .... (like the ones your drill would have for drilling down into the floor boards) You must level it that way First.... then you can use it ...

Same exact features, buttons and functions as this manual by Irwin.

http://www.irwin.com/uploads/documents/36_laser_tape_25.pdf

I want to use an old sensor forgiven during 30 years. I have no more manual, off course. Thanks for your answer

Most moisture meters measure the moisture content of wood or concrete is measured in percentages. So if the reading says 15 that means that there is a content of 15% moisture in the concrete.

Pressing the - (minus) button on the back toggles temperature units. Pressing + (plus) toggles barometric pressure units.

It's possible that one of the newer sensors could work in place of your 1457 sensor, but it depends on the specifications of the newer sensors and the compatibility with your base unit. The I MAX1457 sensor, which is a highly integrated analog-sensor signal processor optimized for piezoresistive sensor calibration and compensation. However, I have no information about its compatibility. If you're looking for a replacement sensor, I suggest contacting the manufacturer of your base unit to inquire about compatible sensors. Alternatively, you can check the user manual of your base unit to see if it lists compatible sensors. Garage door opener sensors are not universal. Safety sensors can only communicate with garage door openers from the same brand.