Hobart AM14C-155 Dishwasher - Answered Questions & Fixed issues
AM 14 C commercial dishwasher.
This sounds like the inlet magnetic solenoid valve is leaking, first thing to try is to turn off the main water valve beside the machine, if the water stops coming in then the inlet water solenoid valve or valves will need to be replaced
Good luck
We have a Hobart AM14C
This are called door guides. Just give them the ML number for you dishmachine and tell them you need replacement door guides.
Good morning, I have 01 Hobart dishwasher AM14, i
294692 for the rinse probe.
"temperature sensor for booster heater"? Do you mean the thermostat? If so, part number is 274161.
Parts breakdowns and part numbers are available at
www.hobartservice.com. Click "Parts" on the left, then click "Hobart SmartParts System" on the next page. You'll be asked a series of questions to identify your piece of equipment, and then you'll get a parts list and have links to parts breakdowns for various sections of the machine.
Do all Hobart dishwashers have a element in them
All Hobart dishwashers will have a wash tank heating element, but the rinse water is not heated by the dishwasher, unless it has a built-in booster heater. Usually a separate booster heater is used to heat rinse water to 180-190 deg. F for hot water sanitation.
How do i convert automatic to manual operation on
It is possible and difficult unless you have enough patience and time.
Requires little electrical wiring knowledge.
You have to understand the machine logic. Note down the sequences. Remove the wires, one by one, and keep notes on every wire and associated parts to which it is connected.
Now group them. Arrange and fix external switches in wooden box. Connect them one by one. Mark the switches like wash, drain etc depending on the device you connect.
Try! you will succeed. It is a challenging job.
Be careful while you are handling electricity.
Can I change the 3 phase to a single phase?
Not practical. You would have to change the pump motor to single phase, you'd have to chage the heating element most likely depending on what size is in it now. Also does it require an auxiliary water heater? it's probably 3 phase also. Changing phases is not like changing voltages.
Dishwasher notworking
is really very easy, remove the two screws and use them to push it out screw them in the two holes whit treads and thats it. (sorry my english, i´m from mexico)
No heat on rinse cycle HOBART AM14C Dishwasher
3 Con, is the booster heat contactor. If it is chattering, the fault will be in the booster. There are a few different boosters in the AM14. can you post the ML number from the data plate, or describe if the booster is a square Hatco HCM-10, or a round stainless booster with a 13 kw multi wired element.. All boosters use a low water cut off circuit, a high limit thermostat and a control thermostat. The old Hatcobooster uses mechanicqal components, where the new rount tank uses probes and a control board. The board has 3 leds. red is calling for heat, yellow is open thermistor, and green is shorted thermistor.
AM14's had a variety of different control circuit voltages, ranging from 240/208/120 and 24 volt AC. Check the transformer secondary for correct output to controls, trace through circuit until voltage pulses. If new style, it could be just scaled up probes not reading water. Drain the tank with the power off before removing probes.
Not finding what you are looking for?