Top 20 Net10 LG Optimus Logic Cell Phone Questions & Answers

Electronics and water do not mix. You can try to turn the volume up, Turn the ring volume up, Try using it with headphones or wireless headphones, Almost anything can be fixed, but at what cost? If the simple things do not get results, there is probably an internal problem, sound amplifier, speaker, switching, or control. Most internal problems would near or exceed the cost of replacement, Sorry!

The browser can be updated from the Play store. With text message issue, i am not perfectly sure.

Go to this net10 tech support page for info: https://www.net10.com/direct/controller.block?__blockname=direct.byop_apn.landing&app=NET10&lang=en&init=Y&TLJID=4TBjTvWJL6S1HJQNQz2 HOW TO UPDATE DATA SETTINGS

perform a hard reset

You have to reset your phone by pressing specific numbers on your dial pad you`ll receive those numbers from your mobile provider so you must call them and also ask them for your access code doing this will delete all the information on your phone but it is the only way to get rid of error code 67.

A group distribution list is a group of contacts that you create that you will then use to distribute (send) the same information to (email). so if you set up a family group, a department group and a company wide group you can then send one email to everyone in your family, department or company.

you have to ring provider for all puk codes

Turn the phone off.Hold down the power,volume, and home keys for a little over ten seconds.After the LG logo appears release the power key.Let it reset.It should delete your data but i would connect it to a computer and backup my data just in case

your phone may not have internet settings for your service provider. you can call customer care to send internet settings on your phne.

my name is Larry and i have the exact same phone. If ur lg isnt turning on and wont charge it could be couple things . either the charging port on ur phone needs replaced and or ur charger has gone bad i would take it to a cell phone repair shop close to you.

phone your net subscriber and get them to change the network settings

Maybe it's not meant to connect to macbook if so then there, or maybe it's either being done wrong or it's wireless is failing with other divices if it still makes calls then you might have just done something wrong.

Hi benchance200, Sounds like a problem with the system board and the graphics. Since you've only had it a week, I would activate the warranty and get it repaired or replaced. Good luck! 10base2

U hold icon then drag to where it says remove at bottom of screen

The IMEI number is unique the each mobile/cell phone. The number is printed on the label under the battery. You can also get the IMEI number by entering this on your phone *#06# It will then display your IMEI number and you may also get a unique global serial number. Your IMEI number should be 15 digits.

what is your old phone make and model?If its the LG then copy all data in memory card and insert card in new phone

How do I delete everything off of this cell?

Reinstall the application

To disable or turn off the MNTR (Monitor) feature on an Executech phone: 1. Find the "MNTR" or "Monitor" button on the keypad or console of your phone. 2. Press the MNTR button once to activate the monitor function, allowing you to listen to a call without being heard. 3. Press the MNTR button again to deactivate the monitor function. This should turn the monitor off.

There are a few things that could be causing this to happen: If you have a USI CSL or USI ARL roll laminator and did not engage the drive switch for 60 minutes, the automatic shut-off timer may have turned off the heat shoe or heated roller.