Schwinn Wide Ride Pedal - Answered Questions & Fixed issues
Square patterns start flashing on console and
follow this steps and fix it. God bless you
Plug it in. The first troubleshooting step is always the
most obvious. Your elliptical machine needs to be plugged in for the
console to work. Ensure that the plug is securely placed into a grounded
outlet and that the outlet is receiving power. Check that the circuit
breaker has not been tripped.
2
Reposition your hands on the handles. If your machine's
monitor is not showing your heart rate, first reposition your hands so
that you are touching the metal contacts. If necessary, clean the
handles with a soft cloth to remove sweat or lotion residue. Do not grip
the handles too tightly or move your hands excessively.
Sponsored Links
3
Calibrate the ramp. If the ramp is not positioned correctly,
it could need to be calibrated. Often this is done from the console.
How you calibrate the ramp is dependent on the make and model of the
machine. Refer to the owner's manual or customer service section of the
manufacturer's website to find out how to reach the calibration settings
on your specific machine. Many companies offer manuals in PDF format
for download on their websites.
4
Adjust the drive belt. Again, your specific make and model
of machine will determine how you do this. Usually, you'll need to
unplug the machine and locate the drive belt area. This is often beneath
the panel housing the wheel and pulley. You may need to find a release
latch or use a screwdriver to remove this cover. Refer to the owner's
manual for your model to make sure you do not damage your machine.
Read more:
http://www.ehow.com/how_6737713_troubleshoot-elliptical-problems.html#ixzz2gWAdfrgF
2/22/2015 5:34:06 PM •
Schwinn Wide...
•
Answered
on Feb 22, 2015
•
253 views
Stepmill 7000 wont regulate speed
Check the blue wire to the alternator. Check all connections. the blue wire is the tach wire. no tach signal and you cant climb fast enough!
9/1/2009 5:47:39 AM •
Schwinn Wide...
•
Answered
on Sep 01, 2009
•
394 views
Stair climbers / steppers maintenance
" * Read all maintenance instructions thoroughly before beginning work.
* In some cases, an assistant is required to perform the necessary tasks, use all precautions.
* The safety level given by the design of this equipment can only be maintained when the equipment is regularly examined for damage and wear.
* Inoperable components should be replaced immediately or the equipment should be put out of use until it is repaired."
12/1/2008 1:20:41 PM •
Schwinn Wide...
•
Answered
on Dec 01, 2008
•
947 views
My Airdyne AD-6 crank arms are ~45* apart, not 180* Can they be adjusted?
It is possible that the crank arms are not seated correctly on the bottom bracket spindle, causing them to be misaligned. Try removing the crank arms and re-installing them, making sure that they are properly aligned with each other and with the bottom bracket spindle. If that doesn't work, there may be an issue with the bottom bracket itself, in which case it may need to be replaced. You can also check the manual for your Airdyne AD-6 to see if there are any specific instructions for adjusting the crank arms.
Not finding what you are looking for?