20 Most Recent Acer Aspire One PC Notebook - Page 2 Questions & Answers

you need to install all the software of this Finger Print Reader and update all the drivers or install the driver.good luck

.swf files are Shock Wave Flash files, which are native to Adobe. Download Adobe Flash Player and you should be able to play them.

Nothing went wrong but it require audio codecs to be installed your DVD drive must be having a CD with it which has nero burning softwares and other like nero show time and dvd codecs. Install this programe from the cd supplied with it. use power DVD etc. many softwares are there .dvd play back

Hi and Welcome to Fixya

Video Codecs are needed if in any case some videos wont recognized by your computer due to different file format. You can download free codecs over the internet and they are absolutely free. Here is the link for one of the codecs available over the internet.

Have a good one!

One bad lead can cause a computer to continue on a cycle or to shutdown or fail to detect your hard drive Test the leads that attach to your ((hard drive from the motherboard)) or replace all the leads that attach to your hard drive including electrical extensions + IDE,SATA and the ones that attach from your ((motherboard to hard drive)) or just replace them they are probably old and faulty a computer needs its connections to have an end so any faulty leads will end up with a computer error hope this helps

You can look in your bios if you didn't turn it off by chance.Otherwise you erase it from your hardware and look for it again in new hardware and install.

Your computer cannot read your copy of Windows from your 'C:' disk-drive.
You need to purchase a replacement disk-drive, and re-install Windows onto the new disk-drive.
I hope that you have a good backup of all your files!

The PXE is a component of your computer's network controller. 1) Press the F2 menu on your keyboard and Setup Utility and click the Boot Tab. Press F12 and check the default settings like the IDE 0 and Network Boot. 2) If you do not notice any hard disk drive, it indicates the absence of a hard drive or hard disk failure. 3) Perform factory reset in your computer and you will restore the default settings of your computer.

Restart your computer during the boot up process you will see which certain key/s to press to enter set up for a very short time usually the Delete or the F2 key this will vary depending on your computer Turn on your Acer Aspire.

Press and hold the "Ctrl" key.

Press and hold the "Alt" key.

Press and hold the "Esc" key. This key combination will open the BIOS on your Acer Aspire. hope this helps

hopless, this is. bitlocker or hdd lockers, hdd encryption was turned on did you do that or the person sold it used to you did that if yes, other person only they can unlock that. or buy new HDD (SSD ,10x better) and start fresh, buy and OS, install it and run , w7 up, or Linux.

on acer website search for model number. it is not n214. u will find it on back! something like AODxx AOHxxx

WOW! after having to pay $$$$ to have my power supply jack "reinforced" (with a 'hot glue gun" the tech told me), because the Toshiba design was not as sturdy as one might like, I was nearly crushed when after less than 14 days I received the black screen and the error notice: "Intel UNDI, PXE-2.0 (build 083) For Atheros PCIE Ethernet Controller yada yada yada..." It is possible to start the computer in Safe Mode- to create a repair disk if you need one and back-up your data files. Timing is critical.... press the start button and be ready to begin pressing the F8 key immediately upon seeing the Toshiba screen, you should receive the options of how to start your computer. If you want to gain access to the BIOS setup, when you press your power button start pressing F2 immediately, where you can then check to see if your system is able to see your hard drive. NO hard drive showing... don't cry yet.... seems that after a bit of road wear, some of the fittings wear loose. Therefore, after doing your backups etc, shut down the computer properly. THEN- remove the battery. Carefully unscrew the cover where the hard drive lives. Carefully pop the cover off, which reveals the hard drive. Using one finger on the securing bracket, lift the hard-drive by only using the sides to touch the device pulling it gently from the "plug". Examine for any debry, you can blow it out with canned air if you feel it is necessary. Look for any worn or scorched contacts- if all looks well, reinsert. The fix - using 1 1/4" (1/4") insulation foam, cut pieces appropriate to apply pressure toward the plug, creating a very snug fit and not interfering with replacing the cover properly. Now replace the cover and be sure to fasten the screws very securely. Replace the battery. You may have to go through one request of how you want to start your computer- and I suggest using safe mode once again and then shutting down the windows normally.The next time you press the power button- hit F2 to go to the BIOS to check to see if the hard drive is now being seen.... if it has 're-appeared", things are looking up. Exit the BIOS and shut down the computer one more time.Now press the power button...... If this was the problem....it should start normally. The cost is a little of your time and the insulation foam, bought at the local hardware store.

USB cd-rom's are pretty inexpensive. Here's a page of examples: https://www.amazon.com/Best-Sellers-Electronics-External-CD-Drives/zgbs/electronics/1292121011 Or you could put a Hirens boot disk on a USB thumb drive and run it. There are articles how to repair that error message. Do a Google search for "NTLDR Missing".

I do not believe there is anything to de-activate! but if your computer rather strangely I would have a professional look at it as it might be compromise.

yes, move out of that humid place! lol, kidding, you might have to get a portable "heater" if that seems to work.

check that the wifi is being managed by Windows and not the application for the wifi, check you wifi settings as well.

Your system will never start without a battery, so forget about that. it sounds like the battery may not be fully seated. Remove and reset the battery. Also, check for the connection pins- make sure none are bent or damaged. Good luck.

METHOD 1: Reset Corrupt Thumbnail Cache Folder First of all try to reset thumbnail cache folder so that it starts storing thumbnail cache files from scratch. 1. Press Win+R keys together to launch RUN dialog box, then type following string in RUN box and press Enter: C:\Users\Username\AppData\Local\Microsoft\Windows\Explorer Replace Username with your correct Windows user account name. If the above trick doesn't work for you. Type appdata in RUN dialog box and press Enter. It'll open AppData folder. Now go to "Local\Microsoft\Windows\Explorer" folder. 2. Once you open Explorer folder, select all files/folders present inside it and delete them. Some files might remain in the folder. Leave them and restart your computer. Now Windows should create thumbnail cache without any problem and it'll not delete them again.

Hi, If you have a way to visit the Acer Support Team website https://www.acer.com/ac/en/US/content/support They would provide assistance on how to resolved your keyboard problem Note: They would verify the warranty of your laptop If the warranty is expired they will give you options on how can they provide support.

http://batteryuniversity.com/learn/