Hello Linda. This should be below my Answer rather than being a new Question. This post has no context to the previous question and my answer. I just happened to see it, but if you clicked Comment under my answer, I would get a notification and come back to help. If I hadn't seen it and someone had answered it with 'not sure what you mean', it would have vanished off the Homepage as Solved and I would never have seen it.
I was just copying Cindy Wells answer, but yes, it is the total cubic feet of both the refrigerator and freezer combined.
https://www.fixya.com/users/linda-adamski
..
The fan that blows cold air from the freezer to cool the refrigerator is not working. If your a little handy with tools its an easy fix. Its located in the freezer. Open your freezer door take off the steel panel at the back of the inside of the freezer. After you remove the panel you will see the fan the blows the cold air up to the Frig. A quick trip to a local appliance store for a new fan with do the trick. Put in the new fan 100% fixed even better than new because the orginal part is defective Kenmore should have recalled them. I have the same frig and its been perfect since I repaced my failed fan.
Kenmore Elite is a who range of appliance, but as you are in Kenmore Refrigerators category, let's assume it's that. All questions need full 'make model (what it is)' first 3 words please.
The only easy thing to do would be to make sure the condenser fins are clear of fluff, the compressor is running, the compressor fan is running and the internal circulation fan is running. If it is a fridge with freezer above, a blockage at the back of the freezer due to a failed defrost heater can cause an issue where no cold air drops into the fridge.
The other possibility is low refrigerant gas, but that is not something you can rectify yourself.
Check the condenser coils to determine if they are dirty-if the condenser coils are dirty, clean them. Verify the freezer temperature is set between 0 and 5 degrees Fahrenheit (-18 to -15 Celsius). Verify the refrigerator temperature is set between 34 and 40 degrees Fahrenheit (1 to 5 Celsius).
Kenmore 106 series
The refrigerator holds 13.6 cu. ft. and the freezer 4 cu. ft. This model is;
Width - 32 and 3/4 inches
Depth - 32 and 1/8 inches
Height - 66 and 3/4 inches
..
It sounds like you have a wire that is not connected to the circuit board. You should be able to locate the connection point for the wire by consulting the user manual for your dryer. If the user manual doesn't have the information you need, you may need to contact the manufacturer or an appliance repair technician to help you identify the connection point.
first need the tools and parts to do the job --parts=== tap a line valve --compressor --oil--freon--electric [depending on why comp failed ]------tools=gauges-torch-solder -hand tools --freon recovery ---vacuum pump --multi-meter
Start by taking a look at the lower or back part of your refrigerator. A grille ought to be visible on both parts. There is a strong likelihood the water filter is inside if you observe the grille. Check the upper-right corner of the refrigerator if the grille on the back or lower portion is not visible.https://www.usawaterquality.org/water-filter-on-a-kenmore-coldspot-refrigerator/
Go to an online appliance parts store and enter your model number on the page. You should get at least one exploded parts diagram. Look at the section for the door - the pieces of the hinge mechanism are shown there. Identify the broken piece. The one I looked at (called a "door cam") was a bit over $5, but I didn't provide a link because I don't know what model you have.
The fun part is figuring out how to disassemble the door so you can change the part. There might be a YouTube video showing the procedure. I strongly suggest having someone help you by holding the door while you undo the fasteners. You may be able to disassemble the broken hinge and leave the other in place (check the parts on that one before you order in case that also needs a new piece), but you should still have a helper.
Any good quality kitchen cleaner can be used to clean the outside, but don't use the ones with bleach or those that are an abrasive like Comet because they can cause rust spotting. Then after rinsing, and drying you can treat the stainless steel with stainless steel cleaner, or even Baby Oil.
https://blackappleappliance.com/products/33-french-door-kenmore-795-71033-010
wikiHowhttps://www.wikihow.com > ... > Cleaning Metals
13 steps
1.
Choose a vinegar. Certain vinegars can work better than others. White and cider vinegar works similarly on stainless steel, but cider vinegar leaves a more ...
2.
Check the direction of the grain. Like wood, stainless steel has a grain that will run either vertically or horizontally. Wiping the steel down in the ...
3.
Spray your steel liberally with vinegar. Pour the vinegar in a spray bottle to lightly coat the stainless
..
Yes ....My Kenmore French Door Bottom Freezer (model ...RefrigeratorPro.comhttps://www.refrigeratorpro.com > my-kenmore-frenc...My Kenmore French Door Bottom Freezer (model 795.7730) Is Made By LG!!! by Debbie ... That repairman attributed it to a cracked water filter.and No ...Kenmore 79577302600 User Manual REFRIGERATOR ...UserManual.wikihttps://usermanual.wiki > Kenmore > htmlHome:Kitchen Appliance Parts:Kenmore Parts:Kenmore REFRIGERATOR Manual. ... 795.7730 ¢, 795.7731 ... If your refrigerator does not have a water filter,
