20 Most Recent
Kenmore 21.9 cu. ft. Side-By-Side Refrigerator with Filtered Ice and Water - Page 9 Questions & Answers
Why has my Freezer stopped freezing?
freezer feeds cool air to fridge via a fan --possible causes ---circuit board failure--evap frozen over--evap fan failure --no power--condenser dirty --condenser fan fail--compressor failure --damage with freon leak---thermostat--
2/8/2022 12:38:33 PM •
Kenmore...
•
Answered
on Feb 08, 2022
Where is the temperature control located for kenmore coldspot refrigerator model 106.51139210
There are two temperature sensors (one in the refrigerator and one in the freezer). The refrigerator sensor is near the front of the compartment on the right side below the door switch and above the slides for the drawers. The freezer's refrigerator temperature sensor is on the left near the top of the compartment. See the two liner diagrams on the page linked below. To change the temperature, press and hold the Temperature button on the LCD panel for 3 seconds. The display should read the current temperature set point and Refrigerator. Use the Acceler-Ice button to lower the temperature in the fridge. Press the Lock button to raise the temperature in the refrigerator compartment. Press Temperature again to see the Freezer set-point and adjust it as above. Note: the temperature in each part of the unit depends on air circulating from the freezer into the refrigerator. Make sure that the vents aren't blocked. Wait 24 hours after adjusting the temperature set points for the unit to reach equilibrium before deciding if the set point should be adjusted further.
Sears Parts Direct has the parts diagrams for the 106.51139210 here:
https://www.searspartsdirect.com/model/4lfq9qfxpx-000582/kenmore-10651139210-side-by-side-refrigerator-parts . This page also has a link to the owner's manual for the side-by-side refrigerator,
https://c.searspartsdirect.com/mmh/pd_download/lis_pdf/OWNM/1302214L.pdf . See page 15 of the manual for the information on setting the temperature set-points.
I hope this helps.
Cindy Wells
11/27/2021 7:33:25 PM •
Kenmore...
•
Answered
on Nov 27, 2021
I purchased a use kenmore upright freezer, model#253.28262803.
Was it delivered lying down?
Did you leave it standing upright for 24 hours after delivery?
Yes, after just 4 hours it should have reached 0'F or -18'C. Now you know why they were selling it. You need a service call. My guess is that it had a small leak and it needs topping up with refrigerant gas. Or you could leave it off 24 hours and see if the liquid part of the gas settles?
11/12/2021 5:56:12 PM •
Kenmore...
•
Answered
on Nov 12, 2021
Not finding what you are looking for?