20 Most Recent KitchenAid KSRA25ILSS Side by Side Refrigerator - Page 7 Questions & Answers

That is not the model number. A Kitchenaid model number will start with a K, followed by a few letter, then numbers, more letters and end with two numbers. Here's an example, KSRA22FKSS00. Once you find the correct model number, there are a number of sites you can use to find parts breakdown. Good Luck

Even though the freezer thermistor passes the test, it's bad. The test only sees if the thermistor is open circuit or grounded. These thermistors can send bad information to board. Replace the freezer thermistor and I think that will solve your issue. Good Luck

That's tough, sorry about issues due to hurricane. Once power was restored, unit should've started with no issues. But I fear that an electrical surge might have taken out a weak component. If lights are working, fans working and control working, but no cooling, it could be the relay/overload on compressor. It could also be a control board that was damaged. It's just hard to say. I suggests to get a qualified service tech to look at. Good Luck

That's interesting, -10 or colder is too cold and something is defiantly going on. This unit is controlled by a mulitple control boards, temperture sensors and other components. Question, what is freezer temp set at? Try increasing it by 3-4 degrees and see if that changes anything. Beyond that, I'm going to change the temp sensor first before doing any of the control boards. #29 is the temp. sensor. Good Luck

That is usually on the model/serial sticker located inside refrigerator section at top. Hopefully the control came with instructions on how to enter service mode and enter code. Otherwise, the unit will not function. Good Luck

https://www.repairclinic.com/Shop-For-Parts/a4/Refrigerator-Parts This link should show x-over part numbers I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

I can't think of any reason moving it would cause that problem. How are your door seals? Are both fans(evaporator fan in freezer and condenser fan at compressor)working? Did you give it 24 hours for temps to stabilize?

Unplug your refrigerator for 10 min. then plug it back in. It should come back on so you can reprogram it to your liking. If It fails to go back to default settings and operate normally, you may need a visit from a service tech. I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

if the unit is sort of new and this is a loud popping (snap) noise, this is a problem with many models and manufacturers. It is a plastic part expanding and contracting during the self-defrost cycle. There is no fix, it is a common "defect" which manufacturers can't or won't rectify. The noise is loud enough to hear in other parts of the house.Good news is mine stopped making noise after about 6 months. It does not affect the performance of the unit. If this is not a newer model, this is most likely not the problem. Good luck

You need to change water tank

Does that unit have a low temperature monitor built in? Maybe that is what is making the noise when your temps dip to -10 degrees. Actually, that is great because the lower the temps the longer you can keep food in the freezer so I would not be overly concerned about that aspect. BTW, have you tried to isolate the source of the humming noise?

have your thermostat setting in the right setting otherwise it will happen again and again. have someone to check it like authorize repair shop or technician

Ok use hand sanitizer or deal with it