20 Most Recent
KitchenAid KSRA25ILSS Side by Side Refrigerator - Page 6 Questions & Answers
I have a Kitchenaid refrigerator kbfs22ewms. Have ice on bottom of freezer. Water seems to be coming from the vents at the bottom of the back of the freezer. While we were away the bottome completely
Thank you for listing a model#!! It really helps to see what you have and lets me diagnose it better for you.
Whirlpool bottom freezers with ice forming on the freezer floor is nothing new. It is formed most likely by an ongoing issue with the design of the defrost drain becoming clogged and there is a revised kit for it part# W10619951.
Whirlpool has extended the warranty of this issue only to two years from the date of purchase and will usually give you the part but charge for install. This is for most models and you would have to call them to verify if it is covered.
It can be put in in less then 10 minutes using just a 1/4" hex bit and a small flat blade screwdriver to release the clip on the old "slide" style drain.
Once installed,it is best to defrost the fridge for at least 24 hours (doors open and unplugged) to make sure all ice is melted from inside the unit.
The problem should not come back afterward
Temperature of refrigerator rising
you have a defrost problem!!!the evaporator coil is getting covered with ice and the evap fan can't blow the cold air from the freezer into the fridge section,you could have a bad jazz board,the machine isn't going into defrost this is your problem send me the full model number,it should be up on the right hand side wall up near the ceiling in the fridge section,if you have the control up in the fridge section on the front top and it's digital saying like 4 and 4 you most likely have a bad jazz board,if so open the door or if you have french doors open the right door,hold the light switch in,press the down key three times,let go of the door or light switch,now press the button down again and you'll see like s and p or something like that then press it down again and it should go back to 4 and 4 shut the door and open the freezer,you just manually put the fridge into defrost,but if the compressor is still running and you'll hear it this is the easiest way to tell the jazz board is bad,after like 5 minutes you should hear the ice crackling if the board is good,that's the heater coming on melting the ice but send me the model number and i can help you out.
Frost in freeze and refrigerator not cooling
Your unit is in need of a auto defrost repair..There are 3 components that might need replacing..1 defrost heater..2 defrost thermostat..3 defrost mechanical timer or newer models have a computer PCB type control..usually all 3 are replaced to guarantee resolve of problem.
The ice maker on my Kitchenaid KBF320EVMS4 french door refrigerator stopped working. The drinking water works fine and I can hear the noise when the ice maker fills with water but no water comes in.
you can pop the cover off of the ice maker,on the module you'll see some letters,if you get a jumper wire and stick it into the T and H the ice maker should start to spin,if it doesn't the ice maker is bad,then remove the wire and stick it into the V and L,water should start to fill the ice maker,if it doesn't most likely you have a bad water valve,just get a piece of wire,strip off both ends to make a jumper wire.one more thing,check the fill cup and the fill line to see if there's any ice in there,if the water valve is bad water can drip through and freeze in the cup or fill line stopping the water from entering the ice maker,if there is melt it out with a hair dryer,also if you have to get in there with a hair dryer be careful with the heat on any plastic parts,you can damage it and don't heat the fuse on the ice maker wires,it's a black fuse built into the harness you can damage it if it gets to hot.you can go here to see your parts
https://www.searspartsdirect.com/model-number/KBFS20EVMS4/0593/0161000.html?searchType=modelSearch&q=KBF320EVMS4&searchTerm=KBF320EVMS4
Opaque white plastic tubing that
There should be plenty of room where the tubing connects to the water solenoids once you get the cardboard cover off. There should be no need to tilt the refrigerator to do the job.
Chirping from kitchenaid refrigerator built in model
I run into this issue a few times. The noise is coming from a control board and it has a weak component. Depending on your model, multiple control boards will have to be replaced. This will take care of the control panel also. Good Luck
Kitchenaid Refrigerator
Built in KitchenAid means your fridge is in the price range of $ 10,000/=.
Most likely the compressor and condenser on the top of the fridge. That is why you get the ringing noise. May be compressor not starting properly. Starting device issue or compressor seized.
Shut off the fridge and call a local service guy or Whirlpool Corporation. No time to test this and that. Your fridge worth $ 10,000/=. Don't be penny wise and pound foolish.
Not finding what you are looking for?