20 Most Recent Kohler 3386-6 Rialto Skylight Round Front Toilet - Page 7 Questions & Answers

Usually this is caused by a sticky valve. The "low-tech" repair method is to just thump the top of the valve fairly hard with your fist. The correct method would involve disassembly and cleaning of the valve interior, or even possibly replacement.

No you just need a new flapper for your flush valve. Its just a 2 minute job.

Try a pumice stone they work great & can make a toilet bowl look brand new, there with the cleaning supplies in any store.D :)

I would suggest a new plunger that will seal.

A grommet seal has disolved. You need to turn off the water main and replace or rebuild the affected shut-off valve or faucet. Use a Monkey wrench. .

not really as the flush time is set by the manufacturer in the design what can be adjusted is the water level in the cistern the more water , the longer the flush before the reset ( shut off)action is activated adjust that by the float screw ot water level adjust screw on the inlet stem

are there any floor drains in the room and an unused bathtub or shower? if so the water may have evaporated from the trap and allow the sewer gas smell. try pouring water into all the drains and see if it is still happening. more elaborate problem may be a broken vent stack in a wall.

sounds like the hot and cold lines were installed backwards.

buy cleaning rope snake

You probably have a water flow reducer in the shower head. It is a rubber disk with a few holes in it. Just remove it and put the shower head back on. They are installed at the factory to save our environment. (Mine are all removed)

Overflow? Seal around drain may be good enough for shower, but leaks with a little more pressure from the filled tub. Filled tub may flex the tub and drain components. What about the overflow. I bet some water is going over, but it isn't used for showers. Double check. Paper towels tied in stratigic locations always help me find a leak. Leak makes the towel soak up water nearby. It's most wet at the point of leak.