20 Most Recent
Eljer Toilet Onepiece Canterbury 081162047 - Page 3 Questions & Answers
When flushed, the toilet (sounds like a lite scream)
try to replace the fluidmaster it is either that or your supply line is kinked,that or check the little black hose inside the toilet tank make sure that hose is not kinked,if neither hose is kinked replace the fluidmaster
Flushing and floatball adjustment problems
sounds as though it needs the thing that lets the water in replaced, now a new one won't resemble your original one (or it might) but don't be alarmed, one fits all, you wouldn't want original replacement, cost to much....get a new one called a "fluidmaster", any hardware store, home depot and the like,....cherio, cracklin joe
When flushed the tank refills and the float goes
Adjust the water level in the tank to the water level line in the tank. If the water is spilling into the open tube in the center of the tank, that will cause the water to run.
If water is not seeping into the tube, then maybe water is leaking through the rubber stopper and into the tank. You will have to replace that rubber stopper
Incomplete flush
If the flapper has a small cup attached to it that drains out slowly while the toilet is flushing, it could be emptying too fast. There should be some small pins attached to the cup that are there to be torn off and used to plug holes in the bottom of the cup. This will slow the drainage down and allow a longer flush.
If not that, look for something similar that will accomplish the same thing by allowing the flapper to remain open longer.
My water tank leaking
Try an epoxy putty on the inside of the tank. If it is a slow leak then this will be fine. If yu have a large crack then you need to replace the toilet as it is nolonger in safe working condition and you would not want to have it break when you are away from home.
Get an epoxy putty that can dry while still wet and roughen up the inside surface of the tank with a bit of sandpaper or steel wool before to give the epoxy a good surface to adhear to.
Hope this helps.
Flush valve
it is all one piece,replace it with the same model. a plumbing supply house is the only place you will find what you need.
Having trouble getting a good power flush.Would
Check the flush regulator - some are adjustable, but if not, they come in 20# and 30# flavors for different water supply pressures. They are located in the tank so you will have to remove the power flush mechanism/assembly to see.
The flush valve to Canterbury is broken and i need change
In the one piece units, there is usually screws that fasten the flush valve onto another piece directly under it. If you would call them, they can guide you to the information you are requesting.
972-560-2000
800-423-5537
Monday through Friday
8:00 A.M. to 5:00 P.M. EST
Motor doesn't turn on.
Do you have the model number? A lot of these systems use a pneumatic tube to send air pressure to a switch. If you have one of those, make sure the tube is not loose or cracked.
2/20/2016 4:51:35 PM •
Eljer Home
•
Answered
on Feb 20, 2016
Not finding what you are looking for?