Duravit 111335001 Geberit In Wall Carrier for Wall Mounted Toilet - Answered Questions & Fixed issues
Water level in bowl is too low so it's a problem
All toilet bowls have a preset water level determined buy the design of the internal s-trap and can not be change. However if the water level in the tank is not as high as it should be this will affect the water put into the bowel as the bowel in refilled by the flush valve and if it is set to stop before it get filled to the proper setting the bowl water level may be low.
A quick test is to see if the water level in the tank is up to the line in the tank most all toilet tanks have a line either stenciled or marked with a indentation in the porcelain. Another way is to mark the level in the bowel with tape or a marker then pour water slowly into the bowel not fast enough to flush it wait to see if it stays higher then the mark you made or settles back to that level.
2/4/2011 9:10:58 AM •
Duravit...
•
Answered
on Feb 04, 2011
•
2,364 views
My geberit in-wall toilet won't
Shut off main water supply
shut off water value going to your wall mounted toilet.
look under your apartment or the room ajoining the wall unit.
look for hidden wall space above unit
11/29/2010 5:03:46 AM •
Duravit...
•
Answered
on Nov 29, 2010
•
7,573 views
Re. Duravit Happy D toilet (tank No. 0929100005)
Remove and clean the flush valve and the flush valve seat(it is the flap that opens up to allow water to flush the toilet). Once the edges of the valve and the seat are cleaned, possibly with "0000" grit bulldog steel wool, it should not leak anymore. To make sure it is not leaking, once tank has refilled completely, put some food die in the tank. If, after 10-15 minutes, the water in the toilet bowl is colored, you have a leak from the flush valve. Replacing the flush valve is very easy - just bring the old one with you to the hardware/plumbing store and ask for a replacement. Blessings and good luck!!
10/5/2017 4:34:53 AM •
Duravit Home
•
Answered
on Oct 05, 2017
•
3,386 views
How to change water level ?
The level is determined by a floating device connected to the water valve. Some are on an angled arm and some move up and down.
Determine how your valve is shut off and either change the big round float or adjust the clips on the rising one.
Just keep the level below the overflow and the flush handle to avoid a running toilet or a leak.
8/22/2014 8:07:15 PM •
Duravit Home
•
Answered
on Aug 22, 2014
•
825 views
Not finding what you are looking for?