Top 20
Oster Golden A5 2-Speed Universal Motor Clipper 78005-140 Questions & Answers
Oster problems. Golden a5 clipper
The blade driving lever is certainly supposed to move, if it isn't then take the cover off and check the cam gear, it's really easy to change it.
My Oster Golden A5 Double Speed clipper is not cutting the hair on my dog?
I bought an Oster Golden A5 new in a pet store in 2000. It did not work reliably out of the box- needed constant tweaking of the blade tension screws. It sat on a shelf for 15 years while I paid for many grooming sessions. Over the years I would try to get it to work; in 2015, I bought a generic brand #5 blade from a beauty supply, and it refuses to cut no matter what I do. Today, I spent 40 bucks on an Andis #10 and low and behold it cuts like a dream. Went back to the store and bought a #5 FC and it also cuts like a dream. So all my troubles were caused by 2 blades that were defective right out of the box...
Cuircuit diagram pwm
Go to http://www.clipperparts.com/schems/oster/professional%20clippers.pdfYou will find the diagram that you are looking for.
My clipper will not cut
See if the hair is clogging somewhere, do you have user guide? Try clippers for dogs or go to the groomers.
Good Luck
Diana
I have just had all the blades sharpened for my
It is common to that a Blade Sharpening Service return your blades just as blunt as before, or even worse.
I advise that you try a new Blade Sharpening Service; trying out only a couple blades to begin with.
I recommend a mobile/on-site sharpening service.
I have an oster a5
Its possible the
gear wheel which is located under the name plate has slipped, if you remove the plate, lever and drive link the gear will pull off.
Inspect the teeth on the gear if there are signs of damage or slipping this is likely to be the problem.
I have oster titan clippers.
ok if the brass inserts are allowing the hinge to move away from the clipper this will obviously cause a few problems, you will need to replace the body housing (new housing comes with a different design) you can view the
clipper parts here
I have not used my
ok rush can be removed with wire wool or a wire brush and will be prevented by the application of oil.
Grease should be inserted into the gearbox which is located under the name plate, for clipper oil have a look at the
page.
I got the blades wet while my A-5 2 speed
My best advise is to send your A5 Clipper to a professional service center or repair dealer. Because you are dealing with electricity caution is need when repairing. Manny's Sharpening has over 20 years in the clipper repair business. They have a mail order service
Check his website
Mannys-sharpening.com
Not finding what you are looking for?