Top 20
Polar AXN300 Heart Rate Monitor Watch HRM AXN300 Questions & Answers
Polar AXN300 Heart Rate Monitor Watch HRM AXN300 is not showing pulse
I would think it is the sensor circuit in the watch. When you replaced the battery did you activate the processor all reset for the watch? I do not know on your model where or how this would be activated.
Electronic watches normally have a reset procedure for when the battery is changed. Very important the watch's processor reset is performed after changing the battery. This is not any of the user readings reset. This is a reset for the watch's processor and system. It is sometimes a contact that has to be shorted out with the jeweler's screwdriver, or it is a contact that has to be shunted, or etc., depending on the model. Maybe if you call the support for the watch they will tell you this. Normally they do not like the user opening the watch.
The time settings for polar f43**********
Not enough information. Is this a serial number and not a model number? All I was able to locate was a book via basic search. We elect how much time we spend on questions depending on the question. Sometimes it is not cost effective to the site of us to offer extensive research when minimum information provided.
good luck
https://www.6ya.com/mrmmike
3/2/2019 6:45:44 PM •
Polar Watches
•
122 views • 0 helpful votes
I have a RS 300.
Please visit my tips and tricks page for reasons why you are not getting a signal. if it takes that long, the number 1 thing to look at is conductivity - so you are either not getting the strap wet enough and takes enough sweat to build up to get a god signal, or it is out of position and takes till you get the strap really wet to make the signal strong enough.
Another thing is turn the watch on, away from other input sources so the watch will key on you, if it is receiving signals from others at the start it will have a hard time knowing which signal to use.
4/14/2011 9:30:56 PM •
Polar Watches
•
205 views • 0 helpful votes
Not finding what you are looking for?