20 Most Recent American Standard 2770.018w.020 Cadet Whirlpool White - Page 2 Questions & Answers

i've been on board during many of these initial start-ups, there is a little red re-set switch on the motor somewhere (you'll see it), it is usually tripped, just push it back in, you'll usually hear it click when you push it in .

Remove access panel make sure pump is plugged in some electricians put a GFI outlet under tub for motor make sure GFI did not trip. Next the switch is an air switch look for the hose going to switch is connected last you may need a new air switch which is common to fail

Jet tools only remove the wall fittings from the jet body. Most bathtub jets are removed by turning them counter clockwise.

Most of these jets turn to close. Check if you turn the nozzle. Hope it helps

no manual. Sounds like the motor is no good. What model and brand of pump do you have?
replacement Bath Pumps

Well there are two things....You say "buzzes?" Like pump is running "humming" & not pushing water. That would be an "airlock" in the pump & it needs to be primed.
If it's "buzzing" & pump motor is not turning (Like it's froze) you might have a bad start up capacitor on the pump that needs to be replaced. Worst case scenerio entire pump needs replacement.

This could be caused by a faulty relay or switch in the control panel. It is best to have a qualified technician inspect the control panel and replace any faulty components. If the issue persists after replacing the faulty components, then it could be a wiring issue and a qualified electrician should be consulted.

To make the water level higher in the pan, the outlet pipe must be higher.

Adjust the float on the fill valve

Depends how old your toilet is, it may be a calcium build up problem on your little inlet pipe inside your tank, but first check your water shut off valve on left side of your toilet near the wall....It may not be open all the way OR the valve has an issue...

Hey, One thing is that maybe there might be some loose plastic shavings in the fill line. From the Factory? or maybe was inside the water line going to the toilet when you connected the line to toilet. Shut off the water and get some towels and something to catch the water and disconnect it from the toilet and use bowl or what ever to catch the water and slowly turn it on and see if anything comes out. Maybe if it is in the line inside the toilet it might fall out by lightly tapping on the fill line inside the toilet to help it fall out. Just a thought when you said it "Sings" that sounds like trash inside the line going to the filler tube and bowl, hey try it who knows it might work. Okay

Hi, First, carefully remove your tank lid, and place it where it won't break or fall. Look for a four-digit number located on the back of the tank, near the water level mark. This is your tank model number. If the number starts with a two, it is a one-piece toilet. Then....visit this link: https://www.americanstandard-us.com/parts-support/faqs/toilets Good Luck!

water level to low or drain partial clog

More likely the sensor has malfunctioned.

these are called phantom flushes. the water is slowly leaking around flapper or the is a scratch of the flapper seat. I use fluidmaster parts

Toilets wear out from mineral deposits. Fixn may cost more then new. Googl used commodes first

Yellowing is a sign of age, but plastic items can be brightened up a bit. Here are some suggestions: http://www.howtocleanstuff.net/how-to-whiten-yellowed-plastic/

air bound or pump overheating

Water turned off or fill valve bad.

https://www.americanstandard-us.com/-/media/sites/asus/files/product-specs/bulk/specsheet5023100.pdf?la=en